4gb90247.fm5 Page 1 Monday, February 11, 2002 3:35 PM
Before using the dishwasher, read the user instructions!
GSI 4453 |
Quick Reference Guide |
GB |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Programme selector knob
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme.
Wash cycle
Pre-RInse Washing Drying
Programme
end
Options
Time and failure display 3)
Indicates in hours the time remaining until the start of the wash cycle. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes.
“F...” Information for the After-Sales Service
“Delayed start” button
The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. Then press the Start button. The dishwasher will start at the set time.
|
|
|
|
Programme chart |
Detergent 2) |
Consumption 3) |
|||||
|
|
|
|
Programmes |
|
Loading instructions |
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
5.0 |
0.02 |
10 |
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Glass |
40°C |
Light soiling, for example |
X |
- |
13.0 |
0.70 |
30 |
|
|
|
|
glasses and cups. |
|||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio Normal 1) |
50°C |
Normally soiled crockery. |
X |
X |
16.0 |
1.24 |
133 |
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Intensive |
70°C |
Heavily soiled crockery, |
X |
X |
17.0 |
1.90 |
125 |
|
|
|
|
||||||||
|
|
|
|
especially pots and pans. |
|||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Reference programme for energy label in compliance with EN 50242 regulations;
2)Refer to “User instructions“;
3)Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.
5019 496 90247
(We reserve the right to make technical modifications)
Black Process Plate
4gb90247.fm5 Page 2 Monday, February 11, 2002 3:35 PM
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the detergent dispenser
Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it).
Large compartment A: |
|
|
With each wash cycle. |
A B |
C |
Small compartment B: |
|
|
For programmes with pre-wash only. |
|
|
Check the |
Mechanical indicator lamp C. |
rinse aid level |
Electric indicator on control panel (if provided). |
|
|
Check the regeneration salt level
Load the racks
Close the door, turn on the water tap
Select a programme
Select additional options
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap, unload the racks
On models with water softener system only.
Mechanical indicator lamp D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Select the desired programme.
The corresponding indicator lamp comes on.
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is then memorised (even in the event of power failure).
“Change programme”
PresstheSTARTbuttonfor2sec.until theStartindicatorlampswitchesoff;
Select another programme and press the START button again.
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob).
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Black Process Plate