Bauknecht GSI 4411 SW, GSI 4411 WS Quick Reference Guide

GSI 4411
Before using the dishwasher, read the user instructions!
Quick Reference Guide
GB
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Programme chart
Programme selector knob
Power supply indicator lamp
Detergent
2)
Consumption
3)
Programmes Loading instructions A B Litres kWh Minutes
Pre-Rinse cold
Rapid 30 min 40°C
Standard
Intensive
1) Reference programme for energy label in compliance with EN 50242 regulations;
2) Refer to “User instructions“;
Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
1)
Crockery to be washed later. - - 8.0 0.02 10
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery. X X 19.0 1.24 133
50°C
Heavily soiled crockery ,
70°C
especially pots and pans.
3) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.
X - 16.0 0.70 30
X X 20.0 1.90 135
(We reserve the right to make technical modifications)
5019 496 90341
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it).
Large compartment With each wash cycle. Small compartment For programmes with pre-wash only.
Mechanical indicator C. Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D. Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Select the desired programme. The corresponding indicator lamp comes on.
A:
CBA
B:
Select additional
options
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is then memorised (even in the event of power failure).
Only after the START button has switched off: access the knob (in case of retractable knob, press and then release the knob).
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press
the START button again.
- Only open the dishwasher if necessary (Warning: beware of hot steam).
- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Loading...
+ 2 hidden pages