Battenfeld Acquisition and Subsidiary 1099107 User Manual
Instructions #1100864 REV. A
Product #1099107
INSTRUCTIONS
1
CONTENT
D.
C .
A.
E.
F.
B.
A. HD Camera
B. Flexible Camera Mount
C. Long Distance Transmitter
D. Router Stand
This system is designed to deliver a live video stream of a target to the shooters
location up to 400 yards away.
This product contains rechargeable batteries that might require
special handling at end-of-life. Please consult your local authorities for proper
recycling/disposal instructions
2
E. Router Stand Stake
F. Wall Charger
G. Storage/Carrying Case
(not shown)
WARNINGS
Changes or modications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
2. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
3. Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
4. FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure guidelines,
place the product at least 20cm from nearby persons.
5. The device must not be co-located or operating in conjunction with any other antenna or transmitter.
POWER OPTIONS
Internal Lithium Ion Battery (Standard Use)
Transmitter
• The transmitter includes an integrated
Lithium Ion battery packs for ease of use.
The transmitter can operate for up to 6
hours on a single charge.
External Power Options (Extended Use)
• Only required when continuous run time is
greater than 6 hours.
• The transmitter includes an external
power jack. This allows the user to utilize an
external power source. This power jack is a
standard male 2.1 x 5.5mm jack.
(Photo 1)
Camera Power
and COM
Mounting
Point
Charge Port
External Power Jack
• The cord, with male 2.1 x 5.5mm jack, can be directly plugged into most standard 12V Battery Banks. (Photo 1)
• You can also connect the male 2.1 x 5.5mm jack to a fused wiring harness designed to work with terminal batteries,
such as deep cycle batteries.
3
Loading...