Battenfeld Acquisition and Subsidiary 1082250 User Manual

INTELLIDROPPER™ ELECTRONIC

POWDER MEASURE

Product #1082250 Instructions #1105521 Rev. A

the INTELLIDROPPER™

Powder hopper cover

Powder hopper tube

(2) 50g Calibration weights

Clear air draft cover

Powder pan

Scale tray

Powder brush

Powder tube
empty spout

Bubble level

Independently leveling feet

NOTICE: For ideal dispensing the INTELLIDROPPER™ Powder Measure
should be used on a stable level surface in an area that has a well-regulated and
stable temperature with minimal air movement or vibrations.

12V DC power supply with cord

(not shown)

Important Safeguards

• Do not store powder in the hopper for long periods of time, this may ruin the device.

• Do no use this device with black powder. This device is intended for smokeless powder only.

• Do no shake, drop, overload unit, or use a power supply different than the one that is supplied.

setting up the INTELLIDROPPER

Using the provided 12V DC power supply, provide power to the device.

NOTE: Allow the device to stabilize for a minimum of 15minutes. Allowing the
device to stabilize will help with its accuracy and precision. Not allowing the device
to stabilize may cause inaccuracies in the device and therefore your charge weight

may uctuate.

While the device is stabilizing adjust the 4 feet on the base of the device to level
it. Use the Bubble Level to accurately determine that the INTELLIDROPPER™
Powder Measure is level.

NOTE: Not leveling the device may cause inaccuracies in how much powder
is dispensed; by up to 0.3 grains difference between the Target Weight and the
actual weight.

Place the supplied Powder pan onto the Scale plate of the device. Do this to prevent
the powder from accidentally dropping onto the scale plate during initial pouring.

Ensure that the Powder tube empty spout cap
is closed so that once you pour powder into
the device it does not fall out of the drain. The
cap twists OPEN and CLOSED. Make sure
the pour window is facing UP for the CLOSED
position

Pour the powder of your choice into
the tube. The tube will hold over 1lb
of powder at a time.

Pour Window should be
UP to close spout