OPERATING INSTRUCTIONS
• Operating instructions:
a. Trailer mode
Press the “a” trailer mode, the corresponding indicator light will light on, by using receiver’s
operating rod to perform the functions of forward moving, back moving, left turning and
right turning. When trailer goes forward, headlamp will light on. When trailer draws back,
rear lamp will light on.
b. Car mode
Press “b” car mode, the corresponding indicator light will light on, by using receiver’s
operating rod to perform the functions of forward moving, back moving, left turning and
right turning.
c. Highway mode
Press “c” highway mode, the corresponding indicator light will light on ,using the receiver
to control both trailer and car at the same time. This mode requires the good technique
in mastering model car as well as the prociency in switching over each function keys.
d. Trailer demonstration mode
Press “d” trailer demonstration mode, trailer will go forward with a pre-programmed trail,
with 20 seconds of show time. When operate the lever on controller or press other mode
during demonstration process, it will stop demonstration and automatically switch to trailer
mode, when press other mode, it will switch to the corresponding mode changed.
• Operation and control
•
In the mode of trailer , when the trailer at the state of resting or moving, press button of “lifting
bracket”, the bracket will lift up slowly. Otherwise, press the button of “landing bracket”, the
bracket will fall down slowly.
lifting bracket landing bracket
•
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be
removed from the toy before being charged. Batteries are to be charged by adult or children
at least 8 years old, leaked or broken batteries are not to be charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Only batteries of the same or equivalent type is recommended to be used.
• The antenna, wire, USB wire or battery plug are not to be inserted into output socket.
• Never put the batteries near re or any source of heat, water or direct sunlight.
•
Skin or clothing is to be washed immediately if you make contact with leaked liquid from
the battery.
•
It is suggested to charge the battery at least one time each three months in order to maintain
the lifetime of battery.
•
Plastic bag is not for playing, as it may cause suffocation. Please keep away from small
children.
• Dispose of battery responsibly. Do not dispose of in re.
• The toy is only to be connected to Class ll equipment bearing the following symbol:
Class ll equipment.
•
When your vehicle starts to lose power,
it may lose its functions or performance.
This indicates that its time to refresh your
batteries or recharge them. Your vehicle’s
running time may change depending on
your driving style.
•
Don’t drive your vehicle in sand or through
water or snow.
•
Radio interference can make your vehicle
run badly. Interference can be caused
by other radio control vehicles running
on the same frequency, electrical wires,
large buildings, or CB radios. Try to stay
away from them!
INSTRUCTIONS
This manual is applicable to the following types of product: 74940,74940-1.
Remind the trailer limit load 500 g.
Frequency bands: 2400 MHz to 2483.5 MHz
Maximum Transmitting Power (EIRP) : Not more than 10 mW.
MAINTENANCE AND REPAIR
• Remove the batteries when the unit is not in use for long periods of time.
• Clean the vehicle with a soft cloth.
• Avoid being heated or being exposed to strong sunlight.
• Keep dry.
•
Regularly examine the toy for any damage to its wires, plug, enclosure and other parts,
and they must not be used until the damage has been repaired.
• In the mode of car, the car is default to at the state of high gear. Press “low gear “button , car
will go forward at a slow speed. Press “high gear” button ,car will go forward at a faster speed.
high gear
low gear
CAUTION
•
Different types of batteries or new and used batteries are not to be mixed. Exhausted
batteries are to be removed from the toy.
•
Batteries should be replaced by an adult. Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short-circuited.
•
Point your transmitter antenna up not
down toward your vehicle. If your vehicle
gets too far away, it won’t work properly. If
your transmitter has an antenna carry-loop
feature, make sure the antenna is removed
from the holder and straightened before
operating.
Car pictures demonstrated above may vary from the toys.
•
Don’t put your vehicle near heat or in
direct sunlight. Always turn switches OFF
after operating.
WARNING:
CHOKING HAZARD-SMALL PARTS.
NOT FOR CHILDREN UNDER 3 YEARS.
The instruction has to be kept since it contains important information.
RASTAR GROUP
Add:Xinghui Industrial Park, Xiadao Road, Shanghua,
Chenghai, Shantou, Guangdong, China.
Http://www.rastar.com
01.04.74940.00702
- 1 -- 6 -- 5 -
BATTERY CHARGE INSTRUCTION
•
Before the rst usage or after a long period of being unused, charge the battery by connecting
the USB wire to any device with USB port such as a desktop, laptop, mobile power source
or USB power socket etc. Steps are as follows:
- Remove the battery from the car before charging. Connect the battery to plug B of the
USB wire, then connect plug A of the USB wire to the power source. The indicator light
of the USB wire will turn on and ash in about 3 seconds (1.5 seconds per ash), which
indicates the battery is being charged normally. When the light goes out, the charging
is completed and power will be automatically cut off. If the indicator light isn’t on, then
the battery is full of power and doesn’t need to be charged.
- If the indicator light ashes three times faster than the normal speed, then something’s
wrong with the circuit or battery. In this case, disconnect the USB plug immediately to cut
off the power, and send the product to local service center or distributor for examination
and repair.
- Make sure the normal power supply of the USB plug before charging.
- Slight heating of the battery or USB wire during the charging is normal phenomenon
and will not affect the battery life or function.
- If the battery can’t be charged, check whether the battery or USB wire is damaged,
otherwise, check if the USB plug is blocked by any foreign object.
A B
It takes 4 to 5 hours to fully
charge the battery at rated
voltage. The charge time
shall not exceed 10 hours.
USB Wire
Battery
of vehicle
BATTERY INSTALLATION AND CODE MATCH
•
Each time before playing model car,please match correlative codes between model car
and receiver. The specic steps are as follows:
- A xed car accessory can be used to open or close the switching knob of battery lab.
See reference drawing 1.
- Put the 2 “AA” batteries into the remote control,cover the battery cover. Then a set of
4.8Vbattery assembly in the car,will be 3 “AA”battery pack in the sedan car ,at the same
time ensure sufcient battery power.
- Place switches to “ON” position of trailer and of car, the headlamp and rear lamp start
ashing (about twice / second), which indicates the status of code matching. Then place
switch of receiver to “ON” position and indicator light begins ashing (about twice /
second), which indicates the status of code matching as well. One or two seconds
thereafter when both of lamps of trailer and indicator of receiver light out, code matching
is completed. At this time, you can perform different functions of model car freely. Please
refer to illustration 2, 3, 4. After code matching completion, it will automatically be in trailer
mode by operating shift lever or any one of the keys except the function mode keys,
and then you can perform different functions of model car by pressing corresponding
function mode key.
•
Please adjust the spinner at the bottom of car to make model car drive along a straight line.
Please refer to illustration 2.
•
When trailer stops and the lamps of trailer ashes slowly (about twice / three seconds)
during operation, or when trailer is switched to demonstration mode and stops after about
5 seconds operation that couldn’t nish the pre-programmed demonstration, or when car
speeds down, or when indicator light of receiver ashes slowly (about twice / three seconds),
it means the low power. The battery of trailer should be recharged, batteries in car and
receiver should be replaced by new ones. Model cars could be operated again by restarting
and code matching after battery recharging and replacement.
1 2
DIRECTION
ADJUSTMENT
DIRECTION
ADJUSTMENT
•
Model car with 2.4 GHZ can be played by many people at the same time without any
interference. However, it must be operated step by step. Please follow the above operating
steps. Firstly, begin the code match of the rst car and keep the state of “ON” of both model
car and receiver. Then start the code match of the second model car and so on.
• After playing, please place switches to ”OFF” position of both receiver and model car.
FEATURES AND FUNCTIONS
•
The product adopts the 2.4 GHZ communication technology and intelligentized system and
design, which enjoys a wide range of applicability. It can be played by multi-device and
multi-user, with rapid respond and precision.
(TRAILER) Lift landing gear
(Car) FAST
FORWARD /
REVERSE
(TRAILER) Landing gear down
(Car) SLOW
LEFT /
RIGHT
The function mode key
a. TRAILER b. CAR
d. DEMO TRAILER c. PUBLIC PASSAGE
Charge the battery by
connecting the USB
wire to any device with
USB port such as a
desktop, laptop, mobile
power source and USB
power socket etc.
SWITCH
OFF
BATTERY BATTERY
3 4
BATTERY SWITCH ON
SWITCH
OFF
SWITCH
ON
Indicator light of trailer extinguished means the
associated code matching completion.
SWITCH
ON
INDICATOR LIGHT
Function: Forward, Reverse, Turn Left,
Turn Right, Headlight and Rear Light,
Demo Trailer, Lift landing gear and
Landing gear down.
Features: Authentic car styling with
injection moulded body, Independent
suspension system.
Function: Forward, Reverse, Turn Left,
Turn Right, Fast / Slow.
Features: Authentic car styling with
injection moulded body,Independent
suspension system.
- 4 -- 3 -- 2 -