Baseline Systems X Cabinet User Manual

Baseline X Cabinet

Wall Mount Enclosure

Installation Guide

Enclosure Mounting Instructions

1. Mount the enclosure on a solid object/foundation taking into consideration wire and conduit

paths to electrical power, and the distance from your wire field.

IMPORTANT! Keep the enclosure out of direct sunlight.

2. Hang the enclosure to wall/pole from a #10 or larger screw.

3. Locate the position for the lower hole and secure the enclosure with #8x1 inch or larger screw.

Materials and Tools

 Hardware (wall anchors, screws,

etc.) for mounting the enclosure

to the wall

 Tools as needed for wall

mounting hardware (drill,

screwdriver, pliers, marker, tape

measure, level, etc.)

 Tools as needed for working with

conduit (cement, cutter, etc.)

 Electrical power connection

hardware (½” conduit, wire, wire

nuts, etc.) and tools as needed

Enclosure Electrical Installation

Hang the enclosure to wall/pole

with a #10 or larger screw

Secure the

enclosure with

#8x1 inch or

larger screws

Note: Baseline recommends that you consult or hire a licensed electrician for these connections.

1. Turn AC power off at the source, and verify that it is off.

2. Run conduit (½” recommended) between the enclosure and the power source.

3. Remove the screw that secures the cover on the wiring compartment, and then remove the

cover.

The electrical installation instructions are continued on the following page...

1-866-294-5847 Rev 11.1.2012 www.baselinesystems.com

Baseline X Cabinet

Wall Mount Enclosure

Installation Guide

Enclosure Electrical Installation, continued...

4. Connect enclosure power leads to facility power and then replace the cover on the wiring

compartment.

5. Connect conduit to the bottom of the enclosure.

6. Route a bare 6 AWG (4.11 mm) earth ground wire into the wiring area through the conduit

opening directly beneath the ground lug, in the bottom of the enclosure. Do not route the

ground wire through the same conduit as the incoming primary AC power!

7. Loosen the ground lug screw, insert the ground wire into the ground lug, and then tighten

the screw to secure the ground wire. Do not overtighten.

8. Power up the BaseStation controller and review the status LEDs on the BaseStation front

panel.

Wi-Fi Modem with Antenna

(optional equipment)

Two-wire

Connections

Zone Terminals

biSensor Port

Labels

Wiring

Compartment

(Remove this
screw and lift
off the cover.)

Ground

Lug

Follow Local Electrical Codes and Practices

1-866-294-5847 Rev 11.1.2012 www.baselinesystems.com