Baseline Systems C Cabinet User Manual

Baseline C Cabinet

Wall Mount Enclosure

Installation Guide

Enclosure Mounting Instructions

1. Mount the enclosure on a solid object/foundation taking into consideration wire and conduit

paths to electrical power, and the distance from your wire field.

IMPORTANT! Keep the enclosure out of direct sunlight.

2. Mount the enclosure with #10 or larger screws.

Materials and Tools

 Hardware (wall anchors, screws,

etc.) for mounting the enclosure

to the wall

 Tools as needed for wall

mounting hardware (drill,

screwdriver, pliers, marker, tape

measure, level, etc.)

 Tools as needed for working with

conduit (cement, cutter, etc.)

 Electrical power connection

hardware (½” conduit, wire, wire

nuts, etc.) and tools as needed.

1-866-294-5847 Rev 11.1.2012 www.baselinesystems.com

Baseline C Cabinet

Wall Mount Enclosure

Installation Guide

Enclosure Electrical Installation

Note: Baseline recommends that you consult or hire a licensed electrician for these

connections.

1. Turn AC power off at the source, and verify that it is off.

2. Remove the screws from the cover of the conduit body, and then remove the cover.

3. Loosen the screw on the grounding lug and route a bare 6 AWG (4.11 mm) earth ground

wire into the grounding lug, and then tighten the screw to secure the ground wire. Do not

overtighten.

4. Connect the enclosure power leads to facility power.

5. Power up the BaseStation controller and review the status LEDs on the BaseStation front

panel.

Follow Local Electrical Codes and Practices

1-866-294-5847 Rev 11.1.2012 www.baselinesystems.com