Bartscher WBS2000 I4HR, WBS1200 I3HR, WBS1600 I3HR, WBS1800 I4HR, WBS1400 I3HR Operating instructions
...
11208
1
IT
EN
DE
FR
MENSOLE RISCALDANTI - MANUALE ISTRUZIONE PER L’USO
HEATED MIDDLE SHELVES - INSTRUCTION MANUAL
WÄRMEBRÜCKE - BETRIEBSANLEITUNG
ETAGERE CENTRALE CHAUFFANTE - MANUEL D’INSTALLATION
112101
112122
112141
112161
112181
112201
ISTRUZIONI ORIGINALI/ORIGINAL INSTRUCTIONS/ORIGINALBETRIEBSANLEITUNG/INSTRUCTIONS ORIGINAUX
ATTENZIONE!: prima di utilizzare l’apparecchio leggere attentamente le istruzioni
WARNING!: read carefully the instructions before using the appliance
ACHTUNG!: vor der Anwendung lesen Sie bitte aufmerksam die aufgeführten Hinweise
ATTENTION!: avant d’utiliser l’appareil merci de lire les instructions
1
SCHEMA DI INSTALLAZIONE
INSTALLATION DIAGRAM
INSTALLATIONSPLAN
SCHEMA D’INSTALLATION
SCHEMA ELETTRICO
WIRING DIAGRAM
SCHALTPLAN
CABLAGE
2
CONTENTS
Type: 2015 40 022
GB
1. INTRODUCTION
2. TECHNICAL DATA
3. INSTALLATION AND COMMISSIONING
4. MAIN RULES
5. USE OF THE APPLIANCE
6. DISPOSAL AND RECYCLING OF THE APPLIANCE
1. INTRODUCTION
This section shows the symbols and provides information about the model of the appliance, the various responsibilities and the copyright.
It concerns heated middle shelf.
For further information refer to paragraph “Technical data” (2).
DATA PLATE
Serial number Week
Year Progressive number
Model
description
Power
supply voltage
Number of phases Liquid protection level
Power supply frequency Max. power input
The data plate shows the identification and technical data of the product.
The data plate is inside the appliance on the right upper part of the heating panel.
The present handbook is intended solely for consultation by the operator. Its content could be modified without notice. The Manufacturer reserves the right to
stop the manufacturing of any model and/or introducing product changes but is not obliged to change products delivered before the modification and declines
all responsibilities for any inaccuracy may appear on this handbook related to printing or translation mistakes.
The company cannot assume liability for damage and faulty operation due to:
• Failure to obey the instructions of this handbook;
• Modification or appliance alteration;
• Maintenance by unspecialized technicians ;
• Insufficient maintenance;
Art.: Heated middle shelf
220-240 V
~
1N
50-60Hz – 400/800 W IPX4
WARNING!
Do not remove, tamper with or erase the “CE” mark of the appliance.
Refer to the data on the “CE” plate of the appliance in all communication with
the Manufacturer (for example: when asking for spare parts, etc..)
The “CE” plate has to be destroyed while scraping the appliance..
Made in Italy
6
• Improper use of the appliance;
RANGE OF HEATED MIDDLE SHELV
ES
2L 3L 4
L
• Exceptional and unforeseeable events;
• Unrespect to domestic legislation on health, hygiene and safety at the workplace;
• The employer is responsible for the periodic training of the operators about the correct use, safety rules and fire prevention.
2.
TECHNICAL DATA
Supply voltage
Frequency
Max. power input
V 220-240 220-240 220-240
Hz 50-60 50-60 50-60
W 400 600 800
Max. current requirement
Power cord
Max. supply Voltage variation
Max. Frequency variation
Max. Frequency variation
A 1,8 2,6 3,5
Mmq-H05RN-F 3x1,5 3x1,5 3x1,5
+/- 10%
continuous +/-1% +/-1% +/-1%
Short period +/- 2% +/- 2% +/- 2%
+/- 10% +/- 10%
WARNING!
The electric power system and the rooms where the appliance is placed have to respect
domestic legislation on safety, accident prevention and fire regulations. On the
contrary the Manufacturer won’t assume liability for direct and indirect damages to
people or things.
3.
INSTALLATION AND COMMISSIONING
WARNING!
Intervention on the electric power system must be solely performed by specialized
electricians.
Proceed according to the following instruction before connecting the appliance:
Remove the packaging and then the protective film taking care not to scratch the surface;
Make sure the power supply of the appliance shown on the data plate is compatible with the grid voltage;
Check the power supply of the system is set up and able to take the current load, and meets the legal requirements and domestic standards;
The appliance must be earthed;
Plug the appliance. In case of direct connection to the electricity grid (without plug), it’s necessary providing for a wall switch, which grants the
complete disconnection according to overvoltage III rate and accordingly to installation rules;
Have the system tested by a qualified electrician, if operation of the equipotential earth connection or the safety of the electrical system is in doubt,
the symbol below identifies the equipotential connection:
The Manufacturer declines all responsibilities in case of connection made by the user or unspecialized staff
WARNING!
This appliance is designed and optimized to ensure high performance and efficiency. The sole use of this appliance is keeping food heated.
After installation dispose of the packaging according to current regulations.
7
WARNING!
Contact with hot tableware can cause burns.
Use always suitable safety equipment while handling objects.
4.
MAIN RULES
The Manufacturer does not assume responsibility for faults or damage due to tampering the appliance. This appliance must be used by skilled persons that must
be periodically trained for its correct use and according to the safety regulations and prevention of accidents. Contact with hot tableware in the appliance can
cause health risks. In order to prevent them use safety equipment and act with suitable caution.
WARNING!
Intervention on the electric power system must be solely performed by
specialized electricians.
5.
USE OF THE APPLIANCE
Press the main switch on the supply panel that powers the appliance.
Switch on the button “A” to position “I”. When the button “A” is switched on, it is lighted up and the appliance is under power and starts operating.
To stop heating turn the switch to “O” position. The heating is so disconnected but the appliance is under power.
Avoid amassing plates and place them under the lights.
Switch off finally the main power supply line ahead of the appliance or plug the appliance off.
Only when the appliance is disconnected, clean the stainless steel surfaces with warm water and a neutral soap, rinse thoroughly and dry carefully.
In case of long period of inactivity, store the appliance in a dry place.
6.
DISPOSAL AND RECYCLING
Dispose of the appliance responsibly and respect the environment at the end of its useful life. Proceed with its disposal in accordance with domestic regulation.
8
Loading...