SERIES CRUX 1
8x
M5x10bolt
(>21U - 12pcs)x
M6x12bolt
(<21U - 8pcs)x
M6x12bolt
(<12U - 10pcs)
x
M6x12 bolt
(>12U - 20pcs)
x
M6x12 bolt
Safety warning – Do not climb on, rock,
shake your rack. Only someone with good
mechanical skill and who has experience
should install this rack. Never exceed the
maximum load capacity. If you didn’t
understood this instructions manual
please contact us by info@barpa.eu
ATTENTION:
please remove front/back door and side
panel from the frame prior to unpacking.
Remove side panel from frame, put them separate for
the preparation of the frame assembly;
Fix 19” mounting rails to the first holes of top & bottom
of side frames by 4sets of M5 screws;
Open the front door by key, pull the door latch downward,
refer to the picture, remove the front door from front
frame, put them separate for the preparation of the
frame assembly;
Install side frames to the grooves of back frame by 4pcs
of M6*12 screws (6pcs if more than 18U) as shown by the
arrow in the picture, note 19” mounting rails are in the
front side;
IM_04
attention:
screws be in
the front side.
Install top and bottom as shown by the arrow in the
picture.
Tip: Please note the direction when install bottom, screws
will be in the front side, please refer to picture;
Install front frame by 4pcs of M6*12 screws (6pcs of
M6*12 screws if more than 18U), refer to the picture;
Install side panels, refer to the picture Repetition step 2, install front door.
Tip: SE enclosure is the bolted structure, need to adjust
the diagonal size of enclosure after the assembly, ensure
homogeneous space for all doors and doors work well.
You are ready to go!
for more informations please go to www.barpa.eu
IM_04
Loading...