Rear Rotor Cover
Page: 1BA-7425RD - BA-7426RD - BA-7427RD
Revision: 1.0 - 03/16/2010
Please read ALL of the instructions BEFORE beginning the installation.
INCLUDED IN THE KIT:
(1) 2 pc Clamp
(1) Rotor Cover
(2) M6x10 Countersunk Screws
(4) M6x20 Chrome Hex Screws
INSTRUCTIONS:
NOTE: We recommend the use of Loctite on all fasteners and mounting hardware
Attach new Rotor Cover blade to the upper part of the clamp with supplied countersunk screws using red
Loctite.
Place clamp assembly on right side of swing arm and align cover with brake rotor.
Attach lower part of clamp to upper clamp with supplied M6 hex screws and torque to 5 - 6 ft.lbs. Use blue
Loctite on these screws.
Check that Rotor Cover does not contact brake rotor while rear wheel is turning.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com tech@baronscustom.com
Loading...