Baron III-L Valves User Manual

Revision: 1.1 - 02/23/2010

INCLUDED IN THE KIT:

Page: 1BA-3165-01
Lay Down License Mount Assembly
Honda VTX1800 Retro

(3) M6x10 Flathead Screws
(4) M5x10 Flathead Screws

(1) Chrome Backing Plate
(1) Chrome License Frame

INSTRUCTIONS:

Note: We recommend the use of Loctite on all fasteners and mounting hardware

Remove stock license holder from rear fender.

Install chrome backing plate with supplied M6 flathead screws into stock holes. Install with open edge down
so light from the tail lamp will illuminate license plate.

Check the fit of your license plate and trim as necessary.

Install license plate frame with supplied M5 flathead screw.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

© 2013 Barons Custom Accessories

5221 Oceanus Drive Huntington Beach, CA 92649 [phone] - Ph. [phone] - Fax www.baronscustom.com [e-mail]