Baron FRONT LOWERING KIT Yamaha Road Royal Star User Manual

FRONT LOWERING KIT INSTALLATION ROYAL
STAR/V-STAR 650/1100

Page: 1BA-7503RS

Revision: 1.1 - 04/07/2010

INCLUDED IN THE KIT:
(2) Machined Aluminum Spacers

CAUTION! WARNING!!! Read this before installing these products! The use

of these products will lower your motorcycle approximately 1.5-inches. The

lowering of either front-end, back-end or both causes the motorcycles

chassis, footboards, exhaust and other products bolted to any portion of the
bike to now be approximately 1.5-inches closer to the ground. When turning
at both low or high speeds, these items can come in contact with the ground.

This contact, should it happen, can cause you some/all loss of control or may
cause damage to the item. We strongly CAUTION the rider of a motorcycle
that has any combination of the lowering products installed to be aware of the

reduction they will cause in the maneuvering of the bike or the damage that

could be caused to any of the items referred to above. Baron Custom

Accessories accepts no liability for any damages stemming from the use of

these products. We do not recommend a lowered motorcycle be ridden with a

passenger!

INSTRUCTIONS:
(A) Remove and disassemble front forks.

(B) Slide the machined spacer onto the forks damping rod in front of the small, stock top-out spring. Once the
spacer is in place, slide the stock top-out spring onto the damping rod. To achieve proper spring preload, you
must cut 1.5-inches from the stock preload spacer. Reassemble the fork, fill with oil and install the fork back
onto the bike. Repeat this process on the other fork.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

© 2013 Barons Custom Accessories

5221 Oceanus Drive Huntington Beach, CA 92649 [phone] - Ph. [phone] - Fax www.baronscustom.com [e-mail]