Baron Celtic Cross Air Cleaner HD XL Models User Manual

Page: 1LA-2395-00(B), LA-2396-00(B), LA-2397-00(B)
Cross Insignia Air Cleaner '93-'06 Big Twin Engines w/stock CV
Carb '01-'13 EFI Softail Models '04-'13 EFI Dyna Glide Models
'02-'07 FLT Models w/Delphi EFI

Revision: 1.1 - 09/06/2012

Install Time: 45 min.

INSTRUCTIONS:

1. First you must remove your stock air cleaner assembly and backing plate via the instructions in your service
manual. The carburetor flange and threaded bosses into the cylinder heads should then be cleaned. Remove the
backing on the supplied gasket and apply to the back of the large chrome backing plate.

2. Mount the large backing plate to the cylinder heads via the supplied spacers and breather bolts. Spacers have
a lip that helps them seat flush in the backing plate. Be sure to use Loctite® when securing the bolts. For Evo
engines, use the larger 1/2-13 breather bolts. For twin cam engines, use the 3/8-16 breather bolts. Tighten
breather bolts lightly allowing minimal play in the backing plate for ease with the next step.

3. Install the three supplied standoffs w/studs through the backing plate and into the carburetor flange. Apply
Loctite® to the threaded studs on the standoffs and secure finger tight (tighten down as much as possible by
hand, they will be torqued in the next step). Secure the breather bolts

CAUTION: We strongly recommend that a qualified technician install this kit

if you do not completely understand the instructions prior to the install.

4. Next install the seal plates that fit into the backing plates, sealing off the air/oil channels from the breather
bolts. Place filter over seal plates, and install cinch plate with supplied black flat head bolts sealing the air filter
and seal plates to the backing plate. Be sure to apply Loctite® to the three flat head bolts. Tighten the bolts

5. Lastly, place the decorative face plate plate into the cinch plate and install the (3) 6-32x3/16" set screws.
These screws will both attach and allow you to center the decorative plate. Clean off the cover and around the
air cleaner assembly. Installation is complete. Be sure to clean and re-oil your air filter on a regular basis. Also,
be sure to re-check bolts after riding to ensure air cleaner assembly remains secure.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. LA Choppers bears no responsibility on installation costs associated with this product.

© 2013 LA Choppers

5221 Oceanus Drive Huntington Beach, CA 92649 [phone] - Ph. [phone] - Fax www.lachoppers.com [e-mail]