Bare Ground B2352794 User Manual

P.O. Box 3477 • Framingham, MA 01705

PROOF

Phone: [phone] • Tollfree: 888-800-8356

Fax: [phone] • www.bareground.com

Email: [e-mail]

Klearway Driveway Deicing System

Instructions

Thank you for purchasing the most unique and functional home
deicing system available. The Klearyway driveway deicing system
is comprised of the following components which have been pre-

assembled for “plug and play” ease of operation and quick nal setup.

AC pump with Smart Switch
10ft blue pickup/feeder hose
50ft. stainless steel hose
Oscillating sprayer applicator

Instructions for Connecting

PROOF

Note that quick connects have been factory installed at all connection
points to the pump and connection points to the oscillating applicator.
Quick connects allow you to make the connections easily.

the oscillating applicator in the middle of your driveway so that you
will not accidentally run over the applicator. The oscillating sprayer
can be adjusted so that the range and width coverage are customized
for the driveway length and width. See the drawing below some
suggested ideas:

Step 1 Connect all “quick connects” to the oscillating applicator

and to the outlet side of the pump. Match colored dots on the pump

to the associated color dot on the pump tting.

Step 2 Connect the blue pickup/feeder hose to the AC pump

matching the colored dots on the pump to the colored dot on the
pump assemblies.

Step 3 Stand the 5 gallon container upright and remove the cap.

Take the cap assembly on the end of the blue pickup/feeder hose and
attach it to 5 gallon container. Note: the assembly also has a “shut
off” lever located just below the cap. Leave this in the open position
for deicing liquid to feed into the pump. Caution: When changing

your supply of Bare Ground deicing liquid, turn this lever to the
off position so liquid remaining in the hose will not accidentally

run out of the hose and leak on to your oor.

Important: Make sure that the 5 gallon container is on its side

when you are using the system. It is recommended that the cap

on the 5 gallon and the attached hose are as close to the ground

as possible. Do not keep it in the upright position because deicing
liquid will be difcult to dispense if the 5 gallon cap is upright
facing the ceiling.

Fig. 2 Fig. 5

Step 5: With the setup complete, you are now ready to plug the

sprayer into a convenient GFI AC outlet. Note that there is an on/
off switch built into the Smart Switch adapter on the end of the plug.
You can choose to use the on/off switch to operate your system. You
can also operate your Klearway deicing system through your Smart
Switch which fully integrates with Google, Alexa and Siri. Time and
interval settings are also available through these smart apps. Here
are the important apps to download: MyStorm and SmartLife

Scan the QR code
to download
Smart Life App

Note: For best results, try to keep the 5 gallon pouch
slightly higher than the pump or level with the pump so

that the lines to the pump are free of air. It is acceptable
to prop up the rear of the container to assist in the ow
of the deicing liquid.

Step 4:

sprayer applicator about ½ way down your driveway. It is
recommended that you position the applicator on the edge of your
driveway (either left of right side) abutting the grass. Avoid placing

Unravel the stainless steel hose and place the oscillating

Note: If you choose to operate your Klearway system manually,

you should only need to run the system for only about 15-45 seconds

in order to give the driveway a sufcient initial coating. It is not

necessary to run the system for many minutes to get the desired
effects. Recommended coating is only about 4oz per square yard.

Note: Because of the length of the hoses, there will be a residual

amount of deicing liquid in the hoses. This can make it appear that
you have used a larger amount of deicing liquid than you’ve used.

Step 6: Changing containers of Bare Groud deicer. Locate the shut

PROOF

off lever on the quick connect assembly that screws to the cap of
the pouch containing the deicing liquid. Turn the valve to the “off”
position and turn the container to the upright position then continue
to unscrew the cap. Replace the container with another supply of
liquid ice melt and follow the instructions Step 3 above. We also
recommend saving the empty pouch for end of season maintenance.

EN

1. Base

2. Spray nozzles (18)

3. Oscillator tube

4. Hose-end

5. Range siding tabs

6. Width sliding tabs 1

7. Width siding tabs 2

8. Inlet lter

9. Cleaning pin

Technical Data

Rubber nozzle heads 18 Coverage Max 4500 sq ft (418m2)

Adjustable range control Yes Motor Turbo drive

Adjustable width control Yes Weight 1.34 lbs (0.6 kg)

Operation

Use range siding tabs to select designed
position and take advantage of the sprinkler’s
adjustable range control (Fig. 1). Refer to
(Fig. 2) to see the different options.

Fig. 1 Fig. 3 Fig. 4

range sliding tabs

Use width sliding tabs to select desired
position and take advantage of the sprinkler’s
adjustable width control (Fig. 3, 4). Refer to
(Fig. 5) to see the different options.

width sliding
tabs 1

width sliding
tabs 2

Maintenance and Care

PROOF

It is recommended that when you are nished using the Klearway
deicing system for the season that you ll an empty pouch of
the deicing liquid with pure water. Reconnect the fresh water

supply to the system and run the system until the hoses, pump

and oscillating applicator are all ushed through. Note: the

hoses and oscillating sprayer can be used during the spring and

summer for all outdoor lawn and garden uses.

P.O. Box 3477 • Framingham, MA 01705

PROOF

Phone: [phone] • Tollfree: 888-800-8356

Fax: [phone] • www.bareground.com

Email: [e-mail]