Bardac 400, 800, 1200, 400E, 800E Catalog Page

DC technology

Single Phase DC Drives for OEMs

Model 370 ... OEM Chassis Drives

Compact, DC drives designed for low cost, non-regenerative,
non-isolated machine controls.

Basic Specification:

Rating: 1/4hp at 90VDC, 1/2hp at 180VDC
Maximum and minimum speed settings
Current limit
Acceleration pot
Suitable 110 or 230 volts, single phase, 50 or 60Hz (not isolated)
For use with permanent magnet or shunt field motors
Approval: CE

Dimensions

4” x 4” x 1.6” (100 x 100 x 40mm)

Models 400, 800, 1200 ... OEM DC Drives (up to 2hp)

Versatile, basic, low cost drives suitable for wide range of machine control applications

Model Amps Description @ 180VDC @ 90VDC Dimensions

400 4 amps Open chassis with screw terminals 0.75hp 0.38hp 5.2”x4.0”x1.6” (130x100x40mm)
800 8 amps Open chassis with screw terminals 1.5hp 0.75hp 5.2”x4.0”x2.8” (130x100x70mm)
1200 12 amps Open chassis with screw terminals 2.0hp 1.0hp 5.2”x4.0”x2.8” (130x100x70mm)

400E 4 amps Enclosed NEMA 1 with pot, switch, fuse 0.75hp 0.38hp 9.9”x7.0”x3.8” (250x177x95 mm
800E 8 amps Enclosed NEMA 1 with pot, switch, fuse 1.5hp 0.75hp 9.9”x7.0”x3.8” (250x177x95 mm
1200E 12 amps Enclosed NEMA 1 with pot, switch, fuse 2.0hp 1.0hp 9.9”x7.0”x3.8” (250x177x95 mm

400ERB 4 amps Enclosed, pot, switch, brake, reverse, fuse 0.75hp 0.38hp 9.9”x7.0”x3.8” (250x177x95 mm)
800ERB 8 amps Enclosed, pot, switch, brake, reverse, fuse 1.5hp 0.75hp 9.9”x7.0”x3.8” (250x177x95 mm)
1200ERB 12 amps Enclosed, pot, switch, brake, reverse, fuse 2.0hp 1.0hp 9.9”x7.0”x3.8” (250x177x95 mm)

Standard features:

Linear torque control
Armature voltage or tach feedback with IR compensation
Calibration range switches (no component changes)
Speed reference 0-10V or 4-20mA
Maximum and minimum speed settings
Adjustable current limit
Independently adjustable up and down ramps
150% overload capacity with 30 second stall timer
Stall and Zero Speed relay driver outputs
Power fuse (up to 12 amps)
Power on and stall indicator LEDs
Stability adjustment
Speed, Ramp Speed and Current signal outputs
International supply voltages 110 / 230 VAC, 50/60hz (not isolated)
Suitable for shunt wound or permanent magnet motors

Approvals: CE

44

Model 1200E