Page 1
Easy Install
Tub Drain
Cat. No.
5598-ITD
INSTALLATION INSTRUCTIONS
Parts Included
• Drop-in drain • 1 Lubricant • Nuts • 1 Gasket • One ½” female adaptor • One ½” male adaptor • 1 brass tailpiece
• 1 Threaded brass tailpiece • 1 PVC pipe
Tools Needed
• Drill • Measuring tape • Glue • Screws or Cement • Channel lock pliers
1. Drill a 4” hole in your
wooden subfloor.
2. Measure the distance
from the inside of the P-trap
to the top of the floor.
(P-trap not included)
3. Cut the ABS or PVC 1
½” pipe 3 inches shorter
than the distance between
the floor and the P-trap.
5. Apply glue to the
outside of the
ABS or PVC 1 ½”
pipe and to the
inside of the
Drop-In drain
insert.
6. Slide the Drop-In
Drain on the
ABS or PVC 1 ½”
pipe making sure
it sits flat on the
floor.
*Please refer to a
local acceptable
plumbing code in
regards to use
of protective
membrane /
underlayment.
4. Apply glue to the outside of
the ABS or PVC 1 ½” pipe
and to the inside of the P-trap.
Insert the pipe into the P-trap.
01/09/2019
7. Insert the
Drop-In Drain cap
firmly into the
Drop-In Drain.
P 847•244•1234 www.barclayproducts.com
Page 2
Easy Install
Tub Drain pg.2
Cat. No.
5598-ITD
8. Secure the Drop-In Drain
to the subfloor with
screws or cement.
9. Install your flooring surface
around the opening of the
Drop-In Drain.
10. Remove the Drop-In Drain
cap with a channel lock
plyer.
12. Affix the appropriate
tailpiece to the waste
& overflow.
Ensure the
measurement
between the base of
the Drop-In Drain
and the P-trap will
accomadate the
tailpiece
Warning: Do not cut
the brass tailpiece
as this may cause
leakage.
13. Apply provided
lubricant halfway up
the tailpiece and
position the bathtub
and tailpiece in line
with the Drop-In Drain.
11. Apply provided lubricant
inside the Drop-In Drain
Please only proceed with
this step once the pressure
test has been performed, if
needed.
01/09/2019
14. With caution, slowly
insert the bathtub
tailpiece into the
Drop-In Drain.
P 847•244•1234 www.barclayproducts.com
Loading...