Bang and Olufsen Beolab 2 Owners manual

BeoLab 2
Guide
CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No User-serviceable parts inside. Refer servicing to qualified service personnel.
WARNING: To prevent fire or electric
shock, do not expose this appliance to rain or moisture.
This symbol indicates that a dangerous voltage constitut­ing a risk of electric shock is present within this unit.
This symbol indicates that there are important operating and maintenance instructions in the literature accom­panying this unit.
DOLBY, DOLBY DIGITAL, PRO LOGIC
are trademarks of Dolby Laboratories
Licensing Corporation.
3
Contents of the Guide
Before you start…
4 Cautions
NOTE! Read this before you start setting up your BeoLab 2.
Connect your speaker system
6 Speaker connections 6 Connection to the mains 7 Setup examples
– Dolby Digital system – Dolby Pro Logic system – Stereo system
Adapt BeoLab 2 to your setup
8 Setting the SETUP switch 8 Placement guidelines 9 Setting the POSITION switch
Daily use
10 Switching on and off – indicator 10 Loudspeaker protection 10 Cleaning BeoLab 2
This Guide describes how to connect the BeoLab 2 subwoofer, and adapt it so that it functions optimally in your speaker setup.
Likewise, the Guide provides guidelines for how to place the BeoLab 2.
4
We recommend that you follow this procedure when setting up the BeoLab 2 subwoofer: – Read and abide by the cautions
on these two pages.
– Disconnect your system from
the mains.
– Connect your speaker system as
described in Connect your
speaker system.
– Set the SETUP switch and the
POSITION switch to the correct settings as described in Adapt
BeoLab 2 to your setup.
– Place BeoLab 2 according to the
guidelines in Adapt BeoLab 2 to
your setup.
– Finally, connect your system to
the mains.
To make a neat cable installation, we suggest that you run the cables through the enclosed cable cover.
Before you start…
Cautions
The BeoLab 2 subwoofer is intended for
use with Bang & Olufsen active (Power Link) loudspeaker systems only – it cannot
be used with other speakers.
Make sure that the BeoLab 2 is placed
and connected in accordance with the instructions in this Guide.
Do not in any way block the free
movement of the BeoLab 2 speaker units, and do not apply any force to them, as this may result in permanent damage!
Place your BeoLab 2 on the floor on its
black rubber foot.
The BeoLab 2 is designed for indoor use
in dry, domestic environments only, and for use within a temperature range of 10–40º C (50–105º F).
Remember that all speakers in a setup
must be connected to a mains outlet, and that they are designed to be connected to the mains at all times, as this allows them to switch on automatically.
Leave enough space for the speaker units to
move – both in front and to the sides of
BeoLab 2.
Use the top hole as a carrying ’handle’ when
you lift BeoLab 2.
Take care not to damage the speaker units,
and never lift BeoLab 2 by gripping its sides!
Bottom view of BeoLab 2 showing the
location of the product identification label (A).
If you wish to adjust the black rubber foot,
place BeoLab 2 upside down and use the two
adjustment screws (B).
B
A
Loading...
+ 8 hidden pages