BAND-IT XE9229 User Manual

Operating

XE9229

Instructions

1. Loop cable tie around bundle. Insert the 2. Slide the tail into the side entry and tail into the buckle and pull tight by hand. position the tool as shown. Position the tool against the base of the buckle.

3. Squeeze the handle to tighten tie to the 4. Maintain final handle pressure and desired tension. rotate cutter bar upward for cut off.

Note: XE9229 is a non-warranty item.

Cable Tie Tensioner

BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925

www.BAND-IT-IDEX.com

Page 1 of 1

Document # P97487 Rev. -

BAND-IT-IDEX, Inc. 2009