BAND-IT Ultra Lok Free End User Manual

two buckle dimples at opposite end

Position the tie on

as shown, insert clamp tail into tool

view of completed clamp

Clamping

Ultra-Lok

Instructions

Warning: Always wear safety glasses when operating tool.

UL2000, UL4000, UL9000, UL9010 Ultra-Lok Tools:

1. Break off an Ultra-Lok Free-End tie from the roll. Slide the buckle onto band with indented arrows pointing in same direction and same side up. Slide buckle all the way onto band until it comes to a stop between the

of tie.

the object you are clamping. Pull the wrapped tie hand tight.

6. Completed clamp should appear as shown.

Side

Prepare Band-It Ultra-Lok tool for operation as described in owners manual. With cut-off handle down

head slot.

2. wrap tie around object to be clamped. Insert the tie through

buckle once for single-wrap or twice for double-wrap.

Tap down buckle

for proper function

Free End

3. If desired, you may pre-form a clamp in the same fashion as step 2.

5. Operate tool until proper tension has been applied. Lift the cut-off handle to cut tail off and form a lock. Excess band can be removed by pulling out from rear of tool or reversing the drill.

BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925

www.BAND-IT-IDEX.com

Page 1 of 2

Document # P07888 rev. F

BAND-IT-IDEX, Inc. 2006

Important:

Clamping Instructions

Inspect buckle on completed clamp and tap down buckle shroud.

buckle, remove clamp and install a new one at reduced tension by lowering the drill clutch torque setting.

Band and Buckle Totes:

Section View

Good Clamp

Bad Clamp

Lock has slipped back under sheared buckle surface

Visually inspect lock formed in band as shown. If lock has slipped under the sheared surface of the

If band end is not accessible, rotate roll band diameter through handle until end snaps into opening.

FRONT VIEW

Completed Free-End Clamp

(Visually inspect lock)

Lock sheared in center and formed inside shroud

Warning:

For safety purposes, retract band until end is between tote side walls.

Ultra-Lok

Free End

Buckle Shroud

Shear Surface

Line up 4 tabs on outside of buckle box with 4 slots in tote. Press into tote.

BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925

Document # P07888 rev. F

www.BAND-IT-IDEX.com

Page 2 of 2

BAND-IT-IDEX, Inc. 2006