BAND-IT Tri-Lokt Swaged Fittings User Manual

p
Installation Instructions
Tri-Lokt Nipples
The number of clamps required to secure a hose on a Tri-Lokt fitting is based upon the design of the shank of the fitting. The larger the diameter of the Tri-Lokt Fitting the more clamps will be required. Our B-80 Catalog lists the number of clamps to be used within the “Hose Fittings” section. The Tri-Lokt design is most effective when installing band clamps under the yoke assembly as well as having a second set on top of the yoke or tie-strip assembly. Failure to follow these instructions may result in an assembly failure when in use.
1. Identify the location where clamps should be installed which is between sealing barbs once the hose has been properly placed. Sealing barbs are less prominent than holding barbs.
INSTALLATION HINTS:
1. The length and diameter of the hose shank will determine how many clamps to be used. See B-80 Catalog, Hose Fittings section.
2. Remember to slide the correct amount of clamps onto the hose end before inserting the fitting into the hose. The first set of clamps will be under the yoke assembly.
3. Tri-Lokt fittings have two sets of hose barbs: sealing barbs for providing a seal against the hose, and holding or locking barbs designed to provide addition al strength to the lock. Clamps should be applied directl y over the sealing barbs, between the holding barbs.
4. Use appropriate size clamps for fitting size.
5. Use BAND-IT brand clam
s.
2. Mark the hose as shown; this will help locate 4. Position and install a clamp over the Tie­ the proper placement of clamps. strips. This secures the hose to the Tri-
slippage.
3. Position and install a clamp under the Tie 5. Apply a clamp over the ends of the Tie­ strips directly over each mark on the hose. strips for additional lock. The location of the clamp’s buckle should be 120° - 180° from each other.
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
Lokt hose nipple and help prevents
Document # P86087 rev. B
www.BAND-IT-IDEX.com
Page 1 of 1
BAND-IT-IDEX, Inc. 2009
© Copyright
All rights reserved
Loading...