BAND-IT S03869 User Manual

1.
2.
3.
4.
5.
Operating
S03869 - BAND-IT
Manual
Tool is designed specifically for 3/8” and 5/8” center punch clamps only. Insert clamp in tool and then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted. Slot must be aligned with clamp tail.
Center Punch Tool
Start “pumping” ratchet wrench forward until proper
tension has been applied.
Place punch on clamp and while holding tension with ratchet wrench, lock clamp by striking punch once or more with hammer, depending on object being clamped.
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
www.BAND-IT-IDEX.com
While holding tension with wrench, pivot tool up against buckle, then backward several times to break off clamp tail.
To loosen clamp tail, wind ratchet wrench until tail is free. Remove ratchet wrench assembly and clamp tail. Caution: Clamp tail may spring back
once released from tool nose.
Document # PO6788 rev. D
Page 1 of 2
BAND-IT-IDEX, Inc. 2006
© Copyright
All rights reserved
Repair Parts List &
S03869 - BAND-IT
Warranty
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
1 2
REPAIR PARTS LIST – S038 CENTER PUNCH TOOL
ITEM
NUMBER
1 J02786* WINDING MANDREL ASSEMBLY
2 S20288 PUNCH HOLDER ASSEMBLY
*
REPAIR PARTS MAY APPEAR DIFFERENT THAN ILLUSTRATED
PART
NUMBER
DESCRIPTION
Center Punch Tool
.
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 2 of 2
Document # PO6788 rev. D
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Loading...