BAND-IT M21050 User Manual

Installation
M21050
Instructions
Scru-Seal
Scru-Seal Installation Instructions
SINGLE WRAPPED
2. Bend end of band toward underside to form a 1”-2” hook and insert in band slot of housing. Wrap the assembly snugly around object and at a point TWO INCHES BEYOND first serration, cut, then bend a second 1”-2” hook toward underside of band.
3. Insert hook into either band slot on both housing and rack and flatten with thumb, forming clamp. Tighten screw with screwdriver to desired tension. Clamp is complete.
DOUBLE WRAPPED
Wrapping TWICE around gives greater strength. For double wrapped, wrap band around object same as step #2 and insert band again through same housing slot and wrap band snugly around second time. Measure and cut same as step #2. Flatten last hook with thumb, check alignment of the two bands and tighten screw with screwdriver to desired tension. Clamp is complete.
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 1 of 1
Document # M21050 Rev. -
© Copyright
BAND-IT-IDEX, Inc. 2007
All rights reserved
Loading...