BAND-IT J07589, J07599 User Manual
Operating
Instructions
J07589/99
Thriftool
For use with BAND-IT® free-end clamps, roll band and clips, JR. clamps, and SID clamps.
Nose
Note:
For extra strength, a
double-wrapped band
is recommended.
Slot
Winding
Mandrel
1 2
1. Wrap band around object
to be clamped. Thread the
band through the buckle
(twice for double-wrapped
clamps) and insert into
nose of tool and slot in
winding mandrel.
2. Place a ½” ratchet
wrench on the winding
mandrel and turn.
®
3 4 5
3. When sufficient tension has
been applied, rotate the Thriftool
over the buckle.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
4. Unwind the band 1 or 2 turns
®
from the winding mandrel and cut,
leaving approximately ½” of band
BAND-IT® JR and SID Clamps:
Follow the same procedure as described above with
one exception: Cut off the tail as close to the buckle
as possible. Tap down any remaining material.
www.BAND-IT-IDEX.com
Page 1 of 2
5. To complete clamp, fold down the
remaining tail of the clamp back over
the buckle and secure it by tapping
down the ears.
Document # P07487 rev. G
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Warranty and
Repair Parts List
Tool Body Handle Grip
J07589/99
Thriftool
Winding Mandrel
PART # DESCRIPTION
J07287 Winding mandrel, Thriftool®
J07387 Grip, Handle, Thriftool®
J07487 Tool body, Thriftool®
REPAIR PARTS LIST FOR J075
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
®
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 2 of 2
Document # P07487 rev. G
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Loading...