BAND-IT J02069 User Manual
1.
3.
4.
5.
6.
2.
7.
8.
9.
Operating
J02069
Instructions
Cut off adequate band from roll of
1/4” or 3/8” BAND-IT band by opening
the slot in the head of the tool with the
cut off lever at right angles to the tool.
Thread the band through the slot and
cut.
Cut off excess band by lifting cutter
lever.
Jr. Preformed Clamps:
Form a clamp by threading the band
through buckle and make a fold under the
buckle. Insert tail of clamp into head of tool
and slide into slot of winding mandrel.
Depress locking pawl and tension clamp
with forward strokes of the ratchet wrench.
Complete clamping operation by
tapping down ears of buckle with a
hammer or mallet.
Pok-It II Tool
When sufficient tension has been applied,
release locking pawl and rotate tool over
object being clamped.
Note: For extra strength double-wrapped
band is recommended.
Remove band wrapped around winding
mandrel by lifting up on locking pawl.
Reverse ratchet and withdraw tensioning
wrench from tool.
Insert tail of the preformed BAND-IT Jr.
clamp into the tool. Tension as shown in
steps 2 & 3. When tensioned sufficiently,
release locking pawl and rotate over object
being clamped. Cut off, leaving stub.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
This stub should be shortened. With
cutter in the open position, Place tool
over stub, insert into slot and trim off
excess.
www.BAND-IT-IDEX.com
Page 1 of 2
Complete clamp by tapping lip of
band over buckle and remove ratchet
wrench from tool as shown in step 6.
Document #P07087 rev. D
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Repair Parts
EXTERNAL RETAINING RINGS
J02069
Pok-It II Tool
RATCHET WRENCH
BAND CUTTER GRIP
WINDING MANDREL
LOCKING PAWL
J020 POK-IT TOOL REPAIR PARTS LIST
BAND-IT
PART #
DESCRIPTION
MANDREL ASSEMBLY WITH WRENCH
J02786*
INCLUDES: RATCHET WRENCH, WINDING MANDREL
AND EXTERNAL RETAINING RINGS
J02587 GRIP
J02488 LOCKING PAWL
J01987 BAND CUTTER
* Repair part may appear different than illustrated.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 2 of 2
Document #P07087 rev. D
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Loading...