BAND-IT ID3016 ID User Manual

Character Dial
ID3016
Instructions
Caution: Table is under tension when pushed all the way to the right.
Character Dial Installation – Install before using imprinter for the first time
Remove table limit screw.
Remove escapement wheel screw and washer, place escapement wheel on axle and replace screw
and washer.
Slide table onto the tool from the left and slide all the way to the right. Replace table limit screw.
Remove screw from center of ram assembly and slide character wheel and dial washer into place.
Replace screw.
Character Dial Replacement
Remove screw in center of dial and take dial and knob assembly off. Slide table to extreme right and remove table limit screw.
To safely return table to the left, hold table to the right and push spacer button to allow table to move slowly to the left and expose spacing mechanism.
Remove escapement wheel screw, dial washer and escapement wheel and replace with parts from kit.
Move table all the way to the right and reassemble table limit screw.
Dial Kits:
Dial kits come complete with dial wheel, escapement wheel, and dial washer.
ID Tag Imprinter
Character Dial Wheel
Catalog Number Description
ID3816 1/16” Letter Dial Kit
ID3906 3/32” Letter Dial Kit
ID3826 1/8” Letter Dial Kit
ID3836 3/16” Letter Dial Kit
ID3846
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
1/4” Letter Dial Kit
Escapement Wheel
www.BAND-IT-IDEX.com
Page 1 of 1
Dial Washer
Document # P71089 rev. A
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Loading...