BAND-IT D51089 User Manual

Installation
D51089, D51289,
D51389
Instructions
BAND-IT® Mounting Plates can be used as a heavy duty bracket securing hardware to poles. There are two sizes of Mounting Plates to accommodate ¾” wide Giant Band with Buckle or 1-1/4” wide Giant Band with Buckle. When using Giant Band and Buckle, we suggest double wrapping each band clamp and tensio ning with our G4026 9 Giant Banding Tool.
Alternative to our Band and Buckle system: Fasten the Mounting Plate to the pole using our same Giant Band and our Bolted Band Retainers. This option allows the installer to tension the band without requiring the G40269 Banding tool and Ear-Lokt buckles. See part numbers listed below as well as installation instructions for the Bolted Band Retainer listed on our website under product instructions as: D50089/99 & D50489/99 Bolted Band Retainer.
Ear-Lokt Buckle Use double wrapped band clamp applied with G40269
tool for maximum strength and holding power. D51089 D51289, D51389
- Use G43099 Band - Use G43299 Band
- Use G44099 Buckle - Use G44299 Buckle
Mounting Plate
Bolt Clamp – See installation instructions P07387 D51089 D51289, D51389
- Use G43099 Band - Use G43299 Band
- Use D5008 9 Bolt Clamp - Use D5048 9 Bolt Clamp
Note: Mounting Plate and Buckle/Bolt Clamp positioned as shown for illustration clarity only. Buckle or Bolt Clamp should be on opposite side of pole as Mounting Plate for highest strength .
BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 1 of 1
Document #P07587 Rev A
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
Loading...