BAND-IT CB1000 User Manual
Operating
CB1000
Manual
A) Use only
BAND-IT brand
name ties.
C) Tighten the tie
snug by hand,
leaving at least a
3” tail.
Cable Bundling
Hand Tool
Operating Instructions
B) Form a tie
by threading
the tail end
through the
buckle.
D) Insert the tail of
the tie into the
head of tool and
the slot of the
winding mandrel.
E) Tension the tie
by repeatedly
squeezing the
handles. When the
desired tension is
reached, release
the handles. Do
not over tension the
tie.
G) Carefully
remove the
excess tail from
the winding
mandrel.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
F) Cut off the
excess tail by
firmly pushing the
cut-off handle
downward.
H) Example of
clamped tie.
Document # P10150 Rev. A
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
Operating
CB1000
Manual
Cable Bundling
Hand Tool
Adjusting Tool Handle Positions
The handles of this tool are adjustable to three pre-set locations to allow for different
orientations of the tool head to the handles. This is for better ergonomics and easier fit in
tight spaces, overhead use, etc. Remove quick release pin from the tool, and insert it in
the desired location.
Position #2
Position #1
Position #3
Quick
Release Pin
Position #1 Position #2 Position #3
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Document # P10150 Rev. A
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
Loading...