BAND-IT C40099 User Manual

Operating

C40099 - Ratchet

Instructions

Instructions:

Wrap object with appropriate band and buckle. Place band through tool as shown. Ensure that
lever block under the cut-off handle is in locked position. Hold the cut-off handle steady while
leveraging the tension handle to desired tension. With tool still in tension, bend band back over the
buckle. Place lever block in open position and pull cut-off handle up until band is cut.
Press the band down between the buckle ears and secure band with a hammer or mallet by
pounding down buckle ears over remaining band tab to complete the clamp.

Tension Handle

Cut-off Handle

Banding Tool

Buckle Ears

Refer to website for warranty information: http://www.band-it-idex.com/warranty.html

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

www.BAND-IT-IDEX.com

Page 1 of 1

Document # P40050 Rev. E

BAND-IT-IDEX, Inc. 2011

Lever Block

© Copyright

All rights reserved