BAND-IT C08569 User Manual

Operating

C08569

Instructions

Tension Release Levers

Nose of Tool

Bantam Hand Tool

Winding Mandrel

Ratchet Handle

Cutter Handle

1. Place end section of band in
open slot of tool nose and
winding mandrel.

Winding Knob

(Also Hammer Surface)

2. To apply tension to band,
move ratchet handle back and
forth. Hold tool with cutter
handle.

3. To complete clamp, roll tool
forward and trim band with
cutter and tap down ears of clip.

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

www.BAND-IT-IDEX.com

Page 1 of 4

Document # P36087 Rev. C

© Copyright

BAND-IT-IDEX, Inc. 2006

All rights reserved

C085 Assembly

C08569

Bantam Hand Tool

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

www.BAND-IT-IDEX.com

Page 2 of 4

Document # P36087 Rev. C

© Copyright

BAND-IT-IDEX, Inc. 2006

All rights reserved