BAND-IT C07569 User Manual
Operating
C07569
Instructions
Nose of Tool
Tension Release
Levers
Ratchet Handle
Winding Mandrel
Handle Locking Pin
Winding Knob
(Also Hammer Surface)
Bantam Hand Tool
Angle Position
Straight Position
Cutter Handle
Handle in Pistol Grip
Position
1. With the Bantam Tool in the Pistol Grip
Position, place the band in the tool with
sufficient band in the winding mandrel.
Pistol Grip Position:
2. With ratcheting action, tension the band until
clamp is tight. If necessary, band may be
repositioned by releasing tension with levers.
Straight or Angle Position:
3. Roll tool over as far as tool will go, and push
forward cutter handle. Remove tool and tap
down ears of clip to complete clamp. Remove
excess material from winding mandrel.
1. With the Bantam Tool in the Straight
Position, place the band in the tool with
sufficient band in the winding mandrel.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
2. With ratcheting action, tension the band until
clamp is tight.
www.BAND-IT-IDEX.com
Page 1 of 3
3. Roll tool over as far as tool will go, and push
forward cutter handle. Remove tool and tap
down ears of clip to complete clamp.
Document # P36287 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
Assembly
*
C07569
Bantam Hand Tool
* ITEM 27 (SPRING)
REQUIRES “C10999” FOR
PROPER INSTALLATION
*
.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 2 of 3
Document # P36287 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
Loading...