Baltech 1057400101A02 User Manual

Operation Manual

Symbol

Parameter

Condition

Min

Typ

Max.

Units

Vdd

Supply Voltage

4 5

5.5

Vdc

Idd

Supply Current

@ 5 Vdd

200

mA

Idd1

Peak Supply Current

Inrush

400

mA

ID-Tablet/10574

REVISION 0.9, 2010-07-22

The ID-Tablet is a RFID Read-/Write-Device (short: reader) which is compatible to read and write
to Mifare® cards. The reader also supports ISO 14443A/B and all cards compliant to these
standards. All functions of reader can be controlled over USB- interface which allows data
exchange with a host computer. This includes:

switch on/off RF-Field
read/write to a transponder

Mounting and Connection

The reader generates a magnetic field with the frequency of 13.56MHz which is influenced by any
electrically conductive material in close proximity to the device. When mounting the unit, a
distance to any such material of minimum 10 cm is required to ensure that there will be no
significant degradation of the performance in terms of read range and reliability. Mounting the unit
directly to metal would result in a severe reduction of read range down to zero functionality. Care
should be taken when testing the device after mounting at a problematic environment: Read ranges
and performance vary from card to card and very much from card to tag or key-fob.

When mounting multiple readers, the distance between readers should be minimum 0.5 m in order
to avoid degradation of performance due to interference.

Technical Data

DC Electrical Characteristics

RF Characteristics

Operating frequency: 13.56 MHz
Data transmission modulation reader to card: ASK
Data transmission modulation card to reader: ASK/load modulation

1

Pin

Name

Type

Description

1

PWR

Power

5V Power Supply

2

D -

Output

USB-data inverted

3

D +

Input

USB-data

4

GND

Power

Signal and Power Ground

Pinout 4-Pin USB-A plug and Signal Descriptions

Temperature

 Operating temperature range: 0…45°C
 Storage temperature range: -20…+60°C
 Thermal shock: 30°C/min maximum dT/dt

Humidity

 Operating: 20% to 80% relative humidity; non condensing
 Non-operating: 5% to 90% relative humidity; non condensing

General regulatory requirements

FCC:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV technician for help.
Canada:

This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique
de la classe B est conforme à la norme NMB-003 du Canada

2