TM
Get Up St and Up
90459
Up-Rite 500 Height Adjustable Standing Desk
Assembly Instructions
Parts List
Hardware List
Part Drawing Description Qty
P-1
P-2
P-3
P-4
Top Panel
Base
Pneumatic Post
Keyboard Shelf
1 EA
1 EA
1 EA
1 EA
Drawing Description Qty
A Screw M6*12mm 4 EA
B Screw M6*38mm 4 EA
C Screw M8*25mm 4 EA
D 2” Locking Casters (for Front) 2 EA
E 2” Casters(for Back) 2 EA
F Allen Wrench 1 EA
G Caster Wrench 1 EA
P-5
P-6 Keyboard Support 1 EA
Bottom Shelf
1 EA
H Spacer 4 EA
I Grommet 1 EA
J Phillips Screw 2 EA
K Screw M6*25mm 2 EA
L Large Washer 2 EA
Assembly Diagram
1.) Identify and seperate all the Parts and Hardware.
2.) Screw in two Locking Casters (D) into the front holes in the bottom of the Base (P2) as shown
in illustration #1. Screw in two Non-Locking Casters (E) into the rear holes on the bottom of the
Base. T ighten Casters using Caster Wrench (G).
E
G
D
illustration #1
P-2
3.) Insert the bottom of the Pneumatic Post (P3) in to the square recess in the Base (P2) and secure
using two Screws (C). Tighten Screws with Allen Wrench (F) as shown in illustration #2.
P3
C
F
P2
illustration #2
4.) Attach the Bottom Shelf (P5) from underneath to the top of the Base (P2) using two Phillips
Screws (J) as shown in illustration #3.
P2
illustration #3
J
P5
5.) Attach the T op Panel (P1) to the top support plate on the Pneumatic Post (P3) from underneath
using four Screws (A) as shown in illustration #4.
P1
A
P3
A
illustration #4
6.) Place a Sp acer (H) between the Keyboard Support (P6) and the Keyboard Shelf (P4) and align
holes. Secure in place using four Screws (B) as shown in illustration #5.
P6
P4
H
B
illustration #5
7.) Open the two clamp levers on the Pneumatic Post’s (P3) keyboard receiver tubes under the top.
Insert the tubes of the Keyboard Support(P6), position and clamp levers to hold in place. Press in
the Grommet (I) into the cut-out in the T op Panel (P1) as shown in illustration #6.
P6
illustration #6
P1
P3
I
8.) Place a Large Washer (L) on Screw (K)
and screw it in the back end of the each
Keyboard Support tube as shown in
illustration #7.
K
L
L
illustration #7
TM
Get Up St and Up
90459
Up-Rite 500 Height Adjustable Standing Desk
T op 18”D X 27”W X 3/4” T
9 1/2”D X 27”W X 3/4”T
Keyboard Shelf
28 1/4”
to
45 1/4”
10”D X 23” W X 3/4”T
Bottom Shelf
2 1/2” Dia. Casters
Pulls Out 4”
26 1/2”
19”
90459_3-27-14
Loading...