BALCO HE180066 Remote Control Manual
REMOTE
CONTROL
REFEREnCE
PHONE HOLDER
ON/OFF BUTTON
PHOTO
360º FLIP
STUNT
VIDEO
B - AUTO
TAKE OFF/
LAND
LEFT
THUMBSTICK
Fly Up/Down
Turn Left/Right
Depress for ne tuning
RIGHT
THUMBSTICK
Fly Forward/
Backward
Fly Left/Right
Headless Mode
Speed Control
Push the left thumb stick up
to the highest point and then
allow the thumb stick to reset
to the centre
ENGAGE PROPELLERS
Push the left thumb stick
down to the lowest level and
hold for approximately 5
seconds until the drone has
landed and powered down
SWITCH OFF PROPELLERS
FLIGHT
Hover Up & Down
Push the left thumb stick up
or down to move the drone
upwards or downwards
Forward & Backward
Push the right thumb stick up
or down to move the drone
forwards or backwards.
Fly Sideways
Pull the right thumb stick left
or right to move the drone to
the left or right.
Turn Left & Right
Pull the left thumb stick left
or right to turn the drone left
or right.
Balco Lifestyle does not take any responsibility for the loss of the Balco FPV HD Camera Drone and it is NOT
covered by warranty. We recommend that users test their drone in a safe indoor environment before attempting
to y the drone outdoors.
We highly recommend that you read the instruction manual in full before attempting to operate and y the drone.
Slide out the cover on the remote control. Insert the Phone Clamp
connector by sliding it down into place as illustrated
Unpack your Balco FPV HD Camera Drone and check that you have
received all components as listed on page 9 of your manual.
Fully charge the drone’s battery before use, using the included USB
Charging Cable
a. Use the QR Codes below, or search for ‘Drone Go’ to download the
drone’s application
b. Switch ON both the remote control and drone
c. On your phone, connect to WiFi Network ‘FPV_WIFI_****’
d. In the ‘Drone Go’ App, click the Start icon to enter the control interface
Push the propeller guard into the slot and push the lever down until
you hear a ‘click’
a. Switch ON both the remote control and drone by pressing the ON/
OFF buttons
b. Move the left thumb stick up then down. You will hear two beeps
and the ON/OFF buttons on both devices will then change to solid
red to indicate pairing is successful
c. To start the propellers, move the left and right thumb sticks
inwards and hold for 2 seconds. Refer to the Instruction Manual for
other take off methods.
Connect the camera wires to the plug port and insert the camera into the
base of drone by twisting the camera 90 degrees until it clicks into place.
The camera should always face forwards toward the head of the drone
Remove the battery cover and Install the 4 x AA supplied batteries into
the back of the remote control.
UNPACK
CHARGE & INSTALL
DRONE BATTERY
OPTIONAL: INSTALL THE
PHONE CLAMP TO USE
YOUR PHONE
ATTACH PROPELLER
GUARDS
PAIR THE REMOTE CONTROL
TO THE DRONE & ENGAGE
THE PROPELLERS
INSTALL THE REMOTE
CONTROL BATTERIES
INSTALL CAMERA
OPTIONAL: DOWNLOAD
THE FPV DRONE
APPLICATION
1
3
5
7
2
4
6
8
GETTING
STARTED
GUIDE
iOS App
(Version 8.0)
Android App
(Version 4.1)
Loading...