Bakers Pride Oven PB-24S, PB-24 User Manual
BAKERS
PRIDE
Model PB-24S
shown with a
FC-616/Y600
IL FORNO CLASSICO
BRICK OVEN
EXHAUST HOOD
Model PB-24
shown with a FC-516
Job ____________ Item # ___________
EYEBROW EXHAUST HOOD
q Model PB-24 — for single decks
q Model PB-24S — for double decks
APPLICATION
Eyebrow style for direct mounting to Il Forno Classico Brick Oven
MAKE-UP AIR
Make-up air must be supplied for replacement of air exhausted
through all kitchen exhaust systems.
Make-up air should be delivered through registers at ceiling height
and distributed throughout the kitchen.
75% to 80% of the replacement air should be fresh, outside air,
conditioned (heated or cooled), distributed directly into the
confines of the kitchen - with the remaining 20% to 25% allowed
to flow into the kitchen from adjacent areas.
SPECIFICATIONS
Furnish Bakers Pride Il Forno Classico Brick Oven Exhaust Hood
Model PB-24 as shown on the plans and as described in the
following specifications.
Exhaust hood shall be constructed of 18 gauge polished stainless
steel.
Construction to meet all requirements of NFPA 96 and NSF
Standard No. 2.
Hood to incorporate full-length semi-concealed grease gutter with a
removable grease cup. Filters to be U.L. Classified stainless steel
baffle type, mounted at a 45 degree angle. Hood shall be equipped
with a full length stainless steel finished back.
Hood Without Fire Damper: Hood shall be U.L. Listed under the
category "Exhaust Hood without Exhaust Damper."
Specify one of the following ovens when ordering hood:
Single Decks
FC-516
FC-616
FC-816
Double Decks
FC-516 / DS-805
FC-516 / D-125
FC-616 / Y-600
FC-816 / Y-800
EXHAUST FANS / MAKE-UP AIR UNITS
Exhaust fans are to be provided and installed by others in
compliance with local codes.
Fans should be induced draft, squirrel cage design, equipped with
backward inclined blades. Fans shall be sized to meet design air
volumes and static pressure drop for the entire system, including
the ductwork.
Discharge ducts should be vertical and located at least ten feet
away from supply air intakes. Supply fans or make-up air units to
be furnished and installed by others in compliance with local
codes. Supply units to be capable of handling the required air
quantity at the total system static pressure and should be
equipped with throwaway or washable filters.
Exhaust and supply fans require a magnetic starter switch with
120 volt holding coil. Coils (exhaust and supply) should be
electrically interlocked for simultaneous operation.
FIRE PROTECTION
NFPA Standard No. 96 and local codes require a fire extinguishing
system for protection of the duct collar and plenum of nonwaterwash ventilators. Hood shall be designed to accommodate
piping for Ansul R-102 fire suppression (plenum and duct
protection). Fire protection system provided by HVAC contractor or
other prescribed contractor. Consult local fire officials for exact
requirements.
BAKERS
PRIDE
BAKERS PRIDE OVEN COMPANY, INC.
30 Pine Street, New Rochelle, NY 10801
914/576-0200 • 1-800-431-2745 • fax 914/576-0605
web: www.bakerspride.com
Continuous product improvement is a policy of Bakers Pride Oven Company.
Therefore, specifications and design are subject to change without notification
2'-0"
2'-2"
24"
4"
(102mm)
PB-24
installation
24"
(51mm)
2'-0"
See Il Forno
specifications
2"
for details
(608mm)
(51mm)
2"
12"
(304mm)
Removable S/S
Grease Cup
(1) Component Hardware
Firefighter Series
Baffle Type Grease Filters
Model #F60-1620
UL Classfied
1 1/2" x 1 1/2" S/S
Mounting Angle
SIDE VIEW
1'-0"
ALL DIMENSIONS NOMINAL
OVEN EXHAUST HOODS
Model
Exhaust
PB-24
PB-24S
Under 500 lbs = Shipping Class # 70
Hood shall be shipped loose with stainless steel mounting angle for installation by FSEC
CFM
540
540
Static
Pressure
0.75
0.75
Duct Size
in. mm.
152x178
6x7
152x178
6x7
in.
1
2
26x25 / x26
1
26x25 / x26
2
PB-24S
installation
mm. lbs. kilos
660x648x660
660x648x660
100
100
(102mm)
Ship Wt.Overall Dimension
4"
24"
(51mm)
See Il Forno
specifications
for details
46
for single ovens
46
for stacked ovens
(608mm)
(51mm)
24"
2"
12" (304mm)
Removable S/S
Grease Cup
(1) Component Hardware
Firefighter Series
Baffle Type Grease Filters
Model #F60-1620
UL Classfied
6" Flue Connection
Flue Duct by E.C. or
other Prescribed
Contractor
1 1/2" x 1 1/2"
S/S Mounting
Angle
BAKERS
PRIDE
BAKERS PRIDE OVEN COMPANY, INC.
30 Pine Street, New Rochelle, NY 10801
914/576-0200 • 1-800-431-2745 • fax 914/576-0605
web: www.bakerspride.com
Continuous product improvement is a policy of Bakers Pride Oven Company.
Therefore, specifications and design are subject to change without notification
HOOD-PB24 — TSW:06/08
Loading...