BAIJUNDA ELECTRONIC WD 282 010Q User Manual

User Manual

Car Mount Wireless Charger

Model No.: WD-282-010Q

Ple ase rea d the man ual car efull y befor e using

Speci fi cat io ns :

Type : Car Mou nt Wire less Ch arger

Mod el No. : WD -282- 010Q

Mat erial : PC(Fi repro of)

Siz e: 100* 135*9 6.5 mm

Inp ut: DC 5V 2 A; 9V 1.6 7A

Cir cuit pr otect ions: h igh tem perat ure,

ove r-cur rent, over- volta ge

and s hort ci rcuit ;

Str uc tu re Di ag ra m:

Wel come to u se BJD wi reles s charg er. It is su itabl e for off ice/h ome/t ravel a nd othe r

occ asion s, with n ewly ch argin g exper ience .

96.5 mm

Tran svers e

bra cket

Cha rging P ad

100 mm

135 mm

Cla mp

Pow er inpu t

Vert ical
sup port

Fea tu re s:

1. Su per-t hin, su itabl e for hom e, offi ce, tra vel, on t he go, wi th high e fficie ncy, rel iabil ity;

wit h sever al prot ectio ns, mee t Qi stan dard.

2. Ch arge ef ficie ncy: Ma ximum c onver sion ra te 85%

3. Wo rking c ondit ion: Tempe ratur e from -1 0℃ to 30℃, hum idity 0 %-90% RH, sea l evel

bel ow 2000 m eters .

4. St orage c ondit ion: Temp eratu re from - 40℃ to 70℃, hu midit y 0%-90 %RH, se a level

bel ow 5000 m eters .

5. Sh ort cir cuit pr otect ion: Ou tput ci rcuit c an be cut o ff imme diate ly unde r the con ditio n of

no- load, w ith loa d ( full- load) a nd reco vered t o work af ter rem oval of s hort ci rcuit f ault.

6. Ov er-lo ad ( curr ent) pr otect ion: wi th over -load p rotec tion, c an be rec overe d to work

aft er remo val of fa ult, ov er-cu rrent v alue ra nge: 1. 2-1.5 A.

7. Lo w- volt age pro tecti on: can a utoma tical ly lowe r outpu t power w hen inp ut volt age is

low er than 4 .7 V, and wil l shut of f outpu t to prot ect mai n circu it if wor se.

8.O ver-t emper ature p rotec tion: w ill ent er into p rotec tion di rectl y when te mpera ture is

det ected t o reach o ver 60℃ an d can be re cover ed to wor k norma lly whe n tempe ratur e

is do wn.

Cauti on s:

1. Pl ease pl ace you r charg e devic e on the su itabl e posit ion ( ref erenc e on the la st page );

2. Pl ease us e suita ble pow er adap ter or it w ill aff ect wir eless c hargi ng effic iency.

3. Ca n use dry c loth to w ipe and c lean th e charg er hous ing, ch emica l clean ers ban ned.

4. Pl ease do n’t put b us card , bank ca rd, ID ca rd or any c ard wit h magne tic on th e side of

cha rger du ring us age of ch arger , or it may l ose sto rage in forma tion.

5. Avo id of usi ng unde r the con ditio ns of low t emper ature , wet, du st, str ong sun shine , high

tem perat ure, cr ash, ex posur e of ligh t, etc.

6. Di sasse mble ho using i s not all owed.

Usage :

Put y our cel lphon e on the ch argin g pad and c onnec t suita ble ada pter to t he

1.

wir eless c harge r.

2.D uring c hargi ng,LE D indic ators w ill ful ly brig ht when c ellph one com plete ly

sta ys on the i nduct ion are a.

Not e: if no in ducti on chip i n your ce llpho ne, ple ase mat ch and we ar

a sui table i nduct ion cov er on you r cellp hone, t hen it ca n be char ged.

Phone and wir eless char ger base matching diagr am

Sch emati c diagr am of cel l phone r ight ch argin g statu s.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

 -Reorient or relocate the receiving antenna.
 -Increase the separation between the equipment and receiver.
 -Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 -Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.