BACtrack SingleShot User Manual

Breath Alcohol Test

INSTRUCTIONS

Before You Test

• Read These Instructions Completely

• Do Not Use If Expired

• Make Sure Crystals Are Yellow Before Using The Test

This Is Not a Self Test.You Should Never Test Yourself.
Alcohol impairs judgement. Have someone who has not
been drinking help you conduct the test and read the results.

™

STEP 1

STEP 2

STEP 3

STEP 4

Step 4

Wait 15 Minutes After Last
Alcoholic Drink.

If the test subject cannot wait, have
subject rinse his/her mouth with water
before taking the test. This removes
alcohol vapors in the mouth that could
cause a false positive result.

Squeeze Only Once, Do Not
Crush or Bend Tube.

Squeeze the middle of the Detector
between thumb and forefinger to break
inner glass tube.

Use the Detector immediately.

Hold Vertically So Arrows
Are Pointing Down and
Blow for 12 Seconds.

Subject should hold Detector vertically so

BLOW

arrows on “BLOW” end are pointing down.
Subject should then BLOW/EXHALE very
hard into tube, in one continuous breath, for
12 seconds. Shake the Detector side-to-side
to distribute the crystals evenly in Detector
window. Lay Detector on flat surface and
WAIT 2 MINUTES.

Read The Results

Positive Results: Most of crystals are

a light AQUA (GREEN/BLUE, BLUE/GREEN)
cast. This shows that the breath alcohol is
at or above the level printed on the Detector.

Negative Results: Most of the

crystals, are light YELLOW. This shows
that the breath alcohol is below the level
printed on the Detector.

The YELLOW does not have to match the
unused Detector. It may be much lighter or
paler YELLOW than an unused Detector.

• The color change may be difficult to see under certain

lighting. For best results, read under lighting such as
incandescent, fluorescent, or indirect sunlight. A flashlight
with an incandescent bulb can be used to help read the
result. Hold the flashlight to the side so that the light does
not fall directly on the Detector.

• Compare results to an unused Detector or to the Yellow

box. If most of the crystals are not GREEN or BLUE (under
the suggested lighting), then the result is negative.

• Detector results may not be reliable if testing is not

conducted according to these instructions.

Please see other side of this pamphlet for important information.

Read All Instructions Before Beginning the Test

Intended Use: BACTRACK® SingleShot™ Alcohol Detector is a test for alcohol in
human breath. It is a disposable screening device for one-time use.

Test System: The Detector is based on indicator chemistry that changes color in
the presence of breath that contains alcohol. See our website for more information
on the chemistry of the Detector. Detectors are calibrated to turn positive at or
above a specific level of alcohol in the breath. This level is called the cut-off. The
cut-off is printed on the left side of the Detector label. For example, the Detector
labeled .08% will turn positive when the breath contains or exceeds .08 percent alcohol.

Preparation and Storage

The Detector is ready to use. Use the Detector immediately after breaking glass tube.

Storage Conditions: 4 to 122°F or -15 to 50°C.

The lot number and “Use By” date is printed on the Detector or the package label.
Do not use the Detector after the “Use By” date.

Warnings, Precautions, and Limitations

• Alcohol impairs judgement. Do not test yourself OR drive if you have been

drinking. Someone who has not been drinking should help conduct the test and
read the result.

• Do not use the Detector if the glass tube containing cr ystals is broken or the

crystals are not Yellow before you begin Step 1 of the instructions.

• Detector results should not be interpreted by readers who are color-blind,

visually impaired, or under the influence of alcohol or any other substance that
may impair their vision or judgement.

• Detector result is best viewed under white light (incandescent, fluorescent or

indirect sunlight). It may be hard to read Detector results under certain
streetlights or under dim lighting. Under yellow streetlights (sodium vapor),
green colors may look gray-green; blue colors may look gray-white. Under
blue-white streetlights (mercury vapor) yellow may look amber-green. A
flashlight with an incandescent bulb, held to the side of the detector, may be
used to help read the result under these lighting conditions.

• Lighting studies were performed following NHTSA (National Highway Traffic

Safety Administration) guidelines. Detector results were read under 5 lighting
conditions. The results met the guidelines except for 1 reading. There was 1
false positive out of 1200 readings of the .04 Detector for a sample that did
not contain alcohol.

• Compare the Detector result to the yellow box on this pamphlet or to an unused

detector of the sa me lot number to help you see if the Detector has turned
GREEN or BLUE indicating a positive result.

• Keep out of reach of children. Do not immerse in liquid.

• DO NOT EAT the contents of the Detector. This Detector contains potassium

dichromate, a hazardous chemical. If eaten, induce vomiting and contact your doctor.

• The Detector should only be used as a screening device and is only an

indication of the possible presence of alcohol in the blood of the subject.
Although breath alcohol levels have been shown to represent blood alcohol
levels, the correlation depends on many factors. The exact level of alcohol
in the blood cannot be accurately determined by using the Detector.

• The Detector does not determine or detect the intoxication of the subject.

Decision’s and/or actions based on the use of this device by any person shall
be at person’s own risk.

• A positive result should be taken as a warning that the subject may have

detectable alcohol in their system. A positive result should be confirmed by an
evidentiary alcohol test before any legal or workplace actions are taken.

• There may be times that a person tests negative and later show that he/she is

under the influence of alcohol or their judgement had been impaired by alcohol.

Technical Assistance: If you have any questions or concerns please call
1-877-334-6876 or email us at [e-mail]. Visit our website for
further information, www.bactrack.com

Distributed by KHN Solutions LLC, 300 Broadway, Suite 26, San Francisco, CA 94133
MADE IN USA

For In Vitro Diagnostic Use

Do Not Drink and Drive