Back Doctor ultimate chiro Assembly Manual

Back Doctor Ultimate Chiro Massage Chair

Assembly Guide

No tools required

Step 1.

Use scissors to cut all the plastic straps binding the
carton.

Step 2.

Unpack the carton.

Remove the cardboard, styrofoam and wooden
protectors.

Step 3.

Carefully lift out the foot massager unit that is wrapped
in plastic atop the chair. Place this somewhere safe.

Back Doctor Ultimate Chiro Massage Chair

Assembly Guide

No tools required

Step 4.

Unwrap the plastic from the chair. Do not use scissors.

Lower the plastic around the base of the chair, so the chair can be
safely lifted out of the box.

This chair is very heavy and we advise for two or three people to
complete the lift together. Lift the chair out of the box and onto a
flat floor.

Take care when lifting so you don’t injure your back.

Step 5.

Unwrap the plastic from the foot massager unit and place it in
front of the chair.

Since the chair is packed into the box in a reclined position, we
need to return it to its default upright position.

Step 6.

Plug the power cord into the back of the chair, and then plug it
into a wall outlet. Plug the remote control cable into the back of
the chair.

Turn on the power and using the remote, raise the backrest of the
chair until it is upright.

Once done, make sure you turn off the power and unplug the chair
from the wall.