Baby Trend 7311 User Manual

Read all instructions BEFORE assembly and USE of product.

KEEP INSTRUCTIONS FOR FUTURE USE.

Model #7311

Sit N Stand LX Tandem Stroller

with Car Seat Snap N Go Attachment System

Instruction Manual

Convenience through innovation and thoughtful design

01.06

WARNING: Please follow all of these instructions to ensure the

WARNINGS

safety of your child. Keep these instructions for future reference.

WARNING: Failure to follow these instructions could result in

serious injury or death. Avoid serious injury from falling or sliding out.

Always use the safety belts and insure that the children are properly

positioned according to these instructions.

WARNING: Never leave children unattended.

* The maximum weight that can be carried in the Parent Tray is 3 lbs. Excessive weight may cause a hazard-

ous unstable condition to exist.

* Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause

hazardous unstable conditions.

* The maximum weight that can be carried in the basket is 5 lbs. Excessive weight may cause a hazardous unstable

condition to exist.
* Be certain the stroller is fully erect and latched in the open position before allowing the children near the stroller.
* The rear stand on platform is designed for a child who is at least 2 1/2 years old and is not over 40 inches tall.

Use of the stroller with two (2) children weighing more than 40 pounds each, or children totaling more than 80

pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to

exist.
* DO NOT use the stroller on stairways or escalators.
* Never allow your stroller to be used as a toy
* To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
* Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair

parts as needed
* Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service Parts

Hotline to arrange for repair or obtain replacement parts.

Please: If you experience any diffi culty with the use of our product or have a question regarding these instructions,
please contact our Customer Service Department at [phone] between the hours of 8:00 am and 4:30 pm
Pacifi c Coast Time. Please do not return to the store as once it is returned it cannot be resold and the materials
and energy used to make it are wasted.

To contact us:

Baby Trend, Inc. Parts Hotline:
1567 S. Campus Ave. [phone]
Ontario, CA 91761 8:00 am and 4:30 pm Pacifi c Coast Time

2

Snap On

Push

Down

PARTS

ASSEMBLING

Child Tray

Foot Rest

Canopy

Front Wheels

Stroller

Rear Wheels

Parent Tray

Snap N Go Attachment

See Page 8

TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

ASSEMBLY

1. Remove stroller from box. The front wheels, rear wheels, child tray, and

canopy need to be installed prior to use.

2. To attach the front wheels, unfold stroller as described in the section

following. See fi gure 1. Lean the stroller backwards so that it rests on
the handle and rear frame tubes and the front wheel tubes are pointing
upward. Position the front wheel assembly at the front tube such that
the large hole in the swivel assembly will slide onto the front tube. Push
each front wheel assembly onto the front tube being careful that wheel
assembly locks onto the front leg. Pull on the wheel assembly to ensure
that it is securely attached to the stroller. Please see fi gure 2.

3. Lean the stroller forward to rest on the front wheels. To attach the rear

wheels, position the rear axle and wheel assembly such that the brake
levers are facing to the rear of the stroller. Press the rear wheel assembly
onto the rear frame tubes being careful that the push buttons on the
forward side of each rear tube engage the hole on the forward side of
each rear wheel housing. Pull on the rear wheel assembly to ensure that
it is securely attached to the stroller. Please see fi gure 3.

4. Ensure that the wheels are fi rmly locked into place. Do Not use the

stroller if the wheels are not locked into place, but rather contact our
customer service department immediately at [phone], between
the hours of 8:00am and 4:30pm PCT, for assistance.

5. Snap footrest onto front legs of stroller just below the seat. Push

downward on the footrest until it locks onto the rivets protruding from
both sides of each leg and snaps onto the U-shaped frame cross member.
Please see fi gure 4.

Fig. 1.

Fig. 2.

Fig. 3.

Fig. 4.

3

6. To attach the front child tray, push the tray onto the front frame tube, lining

Rivet

Shoulder Strap

Squeeze

Crotch Strap

Waist

Strap

Adjust for a

snug fit

up the tray between the protruding rivet and the seat. Push backward on
the latch until snapped into place. The protruding rivet on the outside
of the frame tube should be above the tray latch. Check that the tray is
securely latched in place. Please see fi gure 5 and 6.

7. To remove front child tray, pull outward on the latches and pull outward

on the tray. Please see fi gure 7. Please note that you may attach or
remove one end at a time.

WARNING: The childʼs tray is not a

restraint device: always secure your child with
the seat belt. DO NOT lift the stroller by the
childʼs tray. Use care when attaching the childʼs
tray on the stroller with a child in the stroller.

8. To attach the front canopy, line up the male fi ttings on the canopy with

the female fi ttings on the armrest and push both fi ttings downward until
snapped into place. Please see fi gure 8. Push forward on the front edge
of the canopy to open.

Fig. 5.

Fig. 6.

Fig. 7.

Your stroller is now ready to use

WARNING: Avoid serious injury from

falling or sliding out. Always use the seat belt.

TO SECURE FRONT CHILD
1 The shoulder straps of the 5-point harness has 2 attachment positions.

Select the loop position that places the shoulder strap level with, or below
the top of the childʼs shoulder and feed the shoulder harness under the
correct loop. Please see fi gure 8a.

2. Carefully place the child in the stroller seat and bring the safety harness

around the childʼs waist and over the shoulders. Place the crotch strap
and between the childʼs legs. Insert the male end of each shoulder / waist
belt into the buckle on the crotch strap. Tighten the harness to be snug
around the childʼs waist and over the childʼs shoulders. Please see fi gure

9.

3. To release, apply pressure to both sides of each male clip until the clip

is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child. NOTE: Buckles may be hard
to release when 1st used.

TO SECURE CHILD

Fig. 8.

Fig. 8a.

Fig. 9.

1. The rear platform and jump seat are designed to accommodate a child

who is at least 2 1/2 years old, has good balance and coordination, and
is not over 40 inches tall. Push the jump seat bench to its most forward
position. Position the child on the platform on the back of the stroller.
Be sure child is facing forward and hands are holding frame. Secure the
safety belt behind child and engage buckle. See fi gure 10.

2. Be sure that the childʼs feet are fully on the platform at all times.

TO SECURE REAR STANDING CHILD

Fig. 10.

4

TO USE JUMP SEAT

1. Have child sit on the jump seat facing backwards. Secure the seat belt,

which is attached to the back of the seat, around the childʼs waist, and
buckle to the crotch strap. See fi gure 11.

2. Adjust the seat belt to be snug around the childʼs waist.

3. To release, apply pressure to both sides of the male clip until the clip

is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child.

4. Be sure that the childʼs feet are fully on the platform at all times.

TO ADAPT THE STROLLER TO CARRY

INFANT CAR SEATS

1. Please see Car Seat Chart following to determine the proper confi guration

of the Snap N Go for your Infant Car Seat. See the page following that
corresponds with your brand of infant car seat for use with your car
seat.

Fig. 11.

SEATBACK POSITIONING

1. The front seat has a two position recline. To recline the seat, rotate the

recline bar and press backward on the seat back. Please see fi gure 12. To
place the seat in the upright position, press upward on the seat back while
rotating the recline bar.

2. The upright position should be used only for a child that is at least 6

months old. Note: Seat does not fully recline.

Fig. 12.

5

BRAKES

Release Button

Fold Button

WARNING: Always set brakes when

the stroller is not being pushed so that the
stroller will not roll away. Never leave stroller
unattended on a hill or incline as the stroller
may slide down the hill.

1. To engage brakes, apply light downward pressure to the brake lever

located on each rear wheel. The stroller may require slight forward or
rearward movement in order to line up the teeth on the brake with each
wheel brake cluster. See fi gure 13. Check that the stroller will not move
and that the brakes are properly applied. To release, gently lift up on the
brake lever. See fi gure 14.

CANOPY

1. To open the canopy, push forward on the front frame of the canopies.

To close canopy, pull the front edge toward the rear of the stroller until
folded. Always fold the canopy prior to folding the stroller frame. Please
see fi gure 15.

2. The canopy will ratchet forward or back to block the sun. Pull forward on

the front canopy frame tube to move forward. Pull backward on the rear
frame tube to move back.

3. To remove the canopy, press the lock button on the end of the male fi tting

while pulling upward on the canopy. Please see fi gure 16.

Fig. 13.

Fig. 14.

Fig. 15.

Fig. 16.

TO REMOVE FRONT CHILD TRAY

1. To remove front child tray, pull forward on the locking lever on the tray

arms to unlock. Please see fi gure 6. Please note that you may attach or
remove one end at a time. Also, the tray may be released on either side
and will swing away for easy access to your child. Please see fi gure 7.

TO FOLD STROLLER

Do Not allow children near stroller while folding.

1. Close the canopy as described in the Canopy section above. The canopy

may be folded forward to fold the stroller or, if you need to reduce the size
of the folded stroller, may be folded back toward the rear of the stroller.

2. Unbuckle rear standing safety belt. Please see fi gure 10.

3. To fold the stroller slide the red fold latch safety button in the center of the

handle and squeeze the red handle while pushing forward on the handle.
Once the stroller begins to fold, release the red handle and pull upward on
the child tray until the stroller is folded. Please see fi gure 17.

4. Secure the stroller in the folded position by latching the fold latch, located

on the right side of the stroller handle, over the extended rivet on the
armrest. You may have to rotate the front wheels to fold the stroller
completely. Please see fi gure 18.

Fig. 17.

Fig. 18.

6