BabyTrend 4100 User Manual

DiaperChamp Regular/Medium

Installation

Installation Installation

1. Check if all the parts (3) are in the box. 2. Line up the pail with the base and push

to snap together.

Attention: If you experience any difficulty with the
use of our product or have a question regarding
these instructions, please contact our Customer
Service Department at [phone] between
the hours of 8:00 am and 4:30 pm (PST).

RED AXLE

BABY TREND, Inc.
1567 S. Campus Ave.
Ontario, CA 91761

Installation

1. Check if all the parts (4) are in the box. 2. Line up the pail with the base and push

to snap together.

2a. Mount the pail top.

3. Hold the lid in the indicated position.

Installing the bag

4. Position the axle in the indicated opening

of the pail top.

Use

Attention:

Keep the drum horizontal

5. Push the RED axle on the other side

inward and push the lid in its place.
Caution! The RED button should lock
into the opening.

6. Close the lid. It should lock securely. If it

does not, check if you’ve mounted the
lid correctly.

7. Unlock the lid by

pushing the knob, and
move it all the way up
using the handle.

Installing the bag

8. Push the knob again,

and move the bag
holder downwards
with the other hand.

9. Put the bag through the

hole in the bag holder.
Always use a big
enough bag.

when not in use!

10. The upper side of the bag must be

positioned between the bag holder and
the edge of the pail top. Make sure that
the side of the handle is not covered.

12. Place the diaper in the opening.

13. Turn the handle.

11. Close the lid, until you hear a firm click.

Removing the bag Cleaning the drum Cleaning the drum

14. Unlock the lid with

the knob and move it
up using the handle.
The full bag will be
pulled along.

15. For odorless releasing,

squeeze the bag with
one hand and unlock
the bag holder with
the other hand.

16. Now you can release

and tie the bag.

17. For cleaning the drum,

put in a horizontal
position. Now lift it up
using the knobs on
the side.

18. Push the colored

sleeve away from
the handle using
both thumbs.

19. Remove the knobs

on the side.

20. Now you can separate the two

drum halves.

21. Remove the piston and clean the

parts with warm soapy water.

Caution: Do not submerge the piston.