Babyliss HSB101SDE, HSB100SDE User Manual

• Do not use the unit if it has fallen or if it appears to
be damaged.

• Do not leave the unit unattended when it is plugged
in or switched on.

• Unplug the unit immediately if you have problems
when using it.

• Do not use any accessories other than those
recommended by BaByliss.

• Do not leave the unit plugged into the mains for
longer than 24 hours.

• Unplug the unit after each use and before cleaning it.

• Avoid any contact between the unit’s hot surfaces and
your skin, in particular, your ears, eyes, face and neck.

• This unit is not intended for use by people (including
children) with reduced physical, sensory or mental
capabilities, or by persons who lack experience or
knowledge, unless they are supervised or have been
given instructions beforehand on the use of the unit
by a person responsible for their safety. Children
should be supervised to make sure they do not treat
the unit like a toy.

• Allow the unit to cool before storing.

• If this appliance has been failure or damage, do
not attempt to repair the appliance. Return the
appliance to an authorized service centre for
examination and repair.

• This appliance does not have spare part for repairing.
Contact an authorized service centre for assistance.

• To prevent damage to the cord, do not wrap it around
the unit and ensure it is stored without twisting or
folding it.

END-OF-LIFE ELECTRICAL
AND ELECTRONIC EQUIPMENT

In everybody’s interest and to participate actively in
protecting the environment:

• Do not discard your products with your household
waste.

• Use the return and collection systems available
in your country. Some materials can in this way
be recycled or recovered.

WIRING INSTRUCTIONS

The wires in the mains lead are colored in accordance
with the following code:

BLUE = NEUTRAL
BROWN = LIVE

As the colors of the wire in the mains lead
of this appliance may not correspond with
the color markings identifying the terminals on your
plug proceed as follows:

• The wire which is colored BLUE must be connected
to the terminal which is marked with the letter N.

• The wire which is colored BROWN must be connected
to the terminal which is marked with the letter L.

• With this appliance, if a 13 amp plug is used a 5 amp

fuse should be tted. If any other type of plug is
used a 5 amp fuse must be tted either in the plug

or at the distribution board.

HSB100SDE / HSB101SDE (B69a)

BaByliss International FZE

Dubai Airport Free Zone (DAFZA)

Building 6EA, Ofce 230/231

P.O.Box: 54831, Dubai, U.A.E.

Year:
Made in China

www.babyliss.com

0005-244

HSB100SDE - HSB101SDE

HSB100SDE - HSB101SDE

Read the safety instructions rst.

LISS BRUSH 3D: A NEW HOT STRAIGHTENING BRUSH
FOR A SOFT, GLOSSY, NATURAL LOOK

PRODUCT FEATURES

• Unique combination of 3 bristle types:

• Stiff bristles: effectively untangles hair (1)

• Silicone bristles: great styling comfort (2)

• Ceramic bristles: intense straightening (3)

• Temperature selector: 160°C - 180°C - 200°C (4)

• Temperature indicator light (LED) (5)

• Double ion cannon: hair is twice as glossy without
static electricity (6)

• Swivel cord (7)

• Heat-resistant insulating mat (8)

USE

• Plug in the heating brush and select the desired
temperature using the temperature selector.

As a rule, we recommend using a lower temperature

for ne, bleached, and/or damaged hair, and a higher
temperature for curly, thick, and/or difcult-to-style
hair. The rst time you use it, we recommend using

the lowest temperature, whatever your hair type.
During subsequent uses, you can then increase the
temperature setting if necessary (see table below):

Temperature Hair type

160°C / Yellow

180°C / Orange

200°C / Red

•The indicator light corresponding to the temperature

level selected ashes until the temperature is

reached.

• Use the heating brush on dry hair.

• Untangle hair rst, using a comb.

• Take up a section of hair.

• Position the heating brush under the section of hair,
near the roots. Use the other hand to pull the section
taut to ensure that the brush bristles penetrate deep
into the hair (FIG. 1).

• Slide the heating brush along the hair to the tips,
while keeping it taut using the other hand (FIG. 2).

• Once you have reached the tips, release the section
of hair and end by rotating the handle to give the
section movement (FIG. 3).

• Continue by placing the heating brush on the top of
the section of hair. Always keep the hair taut using
one hand and slide the brush from the roots to the

tips with the other. (FIG. 4-5-6)

• Repeat if necessary.

• Let the hair cool down before combing.

• After use, switch off and unplug the appliance. Allow
the appliance to cool on the insulating mat before
storing.

Notes:

• When using the unit for the rst time, you might

notice a little smoke and a distinct odour: this is
common and will disappear by the next use.

• Each time you use the appliance, you may see some
steam. Do not be concerned, this could be because

Fine, bleached and/or damaged hair

Normal, coloured and/or wavy hair

Thick and/or very curly hair

1
2
3

45

6

7

8

of evaporation of the natural oils of the hair, residual

hair products (leave-in hair products, hairspray,

etc.), or excess moisture evaporating from your hair.

• A heat protection spray can be used to provide
optimal protection of the hair.

• It is quite normal to hear a slight noise, similar to
a crackle: this is the characteristic noise of the ion
generator.

AUTOMATIC SHUT OFF
If the appliance is left switched on for more than 1 hour,
it will automatically shut off.
MAINTENANCE

• Unplug the appliance and allow to cool completely.

• Clean the appliance thoroughly using a soft, damp
cloth without soap to remove all trace of hair styling
products and thereby ensure the maintenance of
optimal quality of the heating parts of the appliance.

SAFETY PRECAUTIONS

• WARNING: the polyethylene bags
over the product or its packaging may
be dangerous. Keep these bags out of
the reach of babies and children. Never
use them in cribs, children’s beds, pushchairs or

playpens. The thin lm may cling to the nose and

mouth and prevent breathing. A bag is not a toy.

• WARNING: do not use over or near
washbasins, bathtubs, showers or other
containers with water. Store the unit in a
dry place.

• If you are using the unit in a bathroom, unplug it

after you have nished using it. Using the unit close

to a source of water can, in fact, be dangerous,
even if the unit is switched off. To ensure additional
protection, have installed in your bathroom a
residual current device (RCD) with a nominal trip

current no higher than 30 mA. Ask your electrical
tter for advice.

• Never immerse the unit in water or any other liquid.

• If the power cord is damaged, it must be replaced by

the manufacturer, its after-sales service or similarly
qualied person to avoid a hazard.

FIG. 1 FIG. 4

FIG. 2

FIG. 3 FIG. 6

FIG. 5