If using this appliance in a bathroom, unplug after use,
as the proximity of water can be dangerous even if the
appliance is switched off. For additional protection, the
installation of a residual current device (RCD) with a
rated residual operating current not exceeding 30mA is
advisable in the electrical circuit supplying the bathroom.
Ask your installer for advice.
WARNING! Do not use this appliance near water contained
in basins, bathtubs or other vessels.
• Do not use the appliance in the bathroom.
• Do not immerse the appliance in water or other liquids.
• Never look directly into the barrel of the dryer when it is
switched on.
• Always inspect the appliance before use for noticeable
signs of damage.
Do not use if damaged, or if the appliance
has been dropped. In the event of damage, discontinue
use immediately and contact the Conair Customer Care
Line (refer to ‘UK After Sales Service’ section for further
information
).
• Do not use the appliance if the lead is damaged. In the
event of lead damage, discontinue use immediately and
contact the Conair Customer Care Line (refer to ‘UK After
Sales Service’ section for further information).
• Do not leave the appliance unattended when switched on
or plugged in.
•
This unit is equipped with a safety thermostat. In the event
of overheating the appliance will either stop automatically
or run hot and cold intermittently. Should this happen,
switch the dryer to the ‘0’ position, unplug and allow to