BaByliss 2777U User Manual

BIG HAIR 42MM AIRSTYLER
2777U

SAFETY CAUTIONS

• This appliance should only be used as described within
this instruction booklet. Please retain for reference.

IMPORTANT CHILD SAFETY
WARNING! Polythene bags over a product or package

may be dangerous. To avoid danger of suffocation, keep
this wrapper away from babies and children. This bag is
not a toy.

WARNING! THIS APPLIANCE GETS HOT!

• ALWAYS keep out of reach of children (during and after

use and whilst cooling).

• This appliance should not be used, cleaned or
maintained by children.

• Always take extra care if used on children or near
children.

• Do not use on very young children.

IMPORTANT SAFETY

• UK Only: This appliance must not be used in
the bathroom.

• Outside the UK: If using the appliance in a bathroom,
unplug after use as the proximity of water can be
dangerous even if the appliance is switched off. For
additional protection the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.

• WARNING! Do not use this appliance near water
contained in basins, bathtubs or other vessels.

• Do not immerse the appliance in water or other liquids.

• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
discontinue use immediately. Contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’
section for further information).

• Do not use the appliance if the lead is damaged. In
the event of damage, discontinue use immediately.
If the lead is damaged it must be replaced by the
manufacturer. Return the appliance to the Customer
Care Centre (refer to ‘UK After Sales Service’ section
for further information). No repair must be attempted
by the consumer.

• Do not leave the appliance unattended when switched
on or plugged in.

• This unit is equipped with a safety thermostat. In the
event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the airstyler to the “0” position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear lter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug, and contact the Conair Customer Care Line
(refer to ‘UK After Sales Service’ section for further
information).

• Do not place the appliance on any heat sensitive
surface whilst in operation.

• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.

• Always ensure that the rear air lter is kept away from
hair during use to prevent it being dragged into the fan
which may cause the appliance to overheat.

• Take care using this appliance when wearing
jewellery, in particular necklaces and earrings to avoid
entanglement in the rotating brush head.

• This appliance should not be used by adults whose
reduced physical, sensory or mental capabilities, or
whose lack of experience and knowledge, might cause
a hazard, unless they have been correctly instructed to
understand the safe use and hazards involved and are
adequately supervised.

• After use, do not coil the lead around the appliance as
this may cause damage to the lead. Instead, coil the
lead loosely by the side of the appliance.

• This product complies fully with all appropriate EU
and UK Legislation and the Standards relevant to this
type and class of appliance. We are an ISO9001:2015
certied company that continually evaluates our
Quality Management System performance. If you have
any queries regarding product safety and compliance,
please contact our Customer Services Department.
(See “U.K. After Sales Service” section for further
information.)

INSTRUCTIONS FOR USE

• Ensure the hair is 80% dry and combed through to remove any

tangles. Divide the hair into sections.

• To turn the appliance on, slide the switch to the heat setting suitable

for the hair type.

• Place the brush underneath the hair section close to the scalp and

hold for a few seconds to boost volume at the roots.

• Use the brush to lift the hair at the roots as you dry.

• Move the appliance down through the hair and start to rotate the

brush away from your head by pressing and holding the appropriate
rotation button.

• As you do this, resist the rotation of the brush by pulling the brush

downwards. This will create tension through the section of hair.
IMPORTANT! It may take several attempts to perfect this technique,
if the brush spins too quickly, simply release the rotation button and
remove from the hair.

• As you reach the ends of the hair section, continue rotating the brush

to roll the ends under.