AzureWave Technologies BT715C User Manual

AW-BT715C

Bluetooth Module

Demo Board User Guide

Version 0.1

- 1 -

Document

Date Modification Initials Approved

release

Version 0.1 2014/06/26 Initial Version N.C. Chen Chihhao Liao

- 2 -

Contents

1. Install driver and tool

install active perl version: 5.8.4.810 before install Broadcom tool

install Broadcom tool BLUETOOL version:1.7.3.3

install CP210X(USB to UART ) driver CP210X_VCP_Win2K_XP_S2K3

2. Connect the EVB to a PC

Use the cable to connect EVB with PC

- 3 -

Check the com port that will be used.

A.CONNECT TO A BLUETOOTH TESTER

Run BlueTool, and then:

- 4 -

1. From the BlueTool View menu, select Log Window. A record of issued commands will be maintained in
the log window.

2. From the Transport menu, select HCI Control.

a. In the Select HCI Control Window Transport window (screenshot below), select UART, the COM port that
will be used, 115200, and CTS flow control.
b. Click OK.

- 5 -

- 6 -

B. Reset

1.In the HCI Control window

a. Select 7.3 Host Controller & Baseband Commands (3 key) for HCI protocol active
b.Double-click Reset.

2. Confirm that this step is done successfully by viewing the log window

C. Download the Configuration File

1. In the HCI Control window
a. Select 0: Vendor-specific Commands (0 key) for HCI protocol active
b.Double-click Download Minidriver.

2. Confirm that this step is done successfully by viewing the log window

- 7 -

3. From the BlueTool Transport menu, select Download Firmware/Config….

4. In the Select Download Firmware/Config Transport window

a. select UART, the COM port that will be used, 115200,and CTS flow control.
b. Click OK.

- 8 -