Azumi S A AZUMILT50 Users manual

WELCOME

 Congratulations on your purchase of the Azumi mobile phone. Your phone provides many functions which

are practical for daily use, such as a hands-free loudspeaker, camera, MP3 player, Ultra clear video , WIFI and
GPS.

 You can read the manual to understand how to use Azumi mobile phone and experience the

well-established functions and simple operation method. Please use the original accessory in order to achieve
the best use of effects. Azumi shall not be responsible for any damage in machinery due to use of non-original
components.

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does
not cause harmful interference.
Caution: Changes or modifications not expressly approved by the manufacturer could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.

Health and safety information
Radio Frequency (RF) Energy

This model phone meets the government’s requirements for exposure to radio waves.
This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S. Government:
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using standard
operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only the poser required to reach the network. In
general, the closer you are to a wireless base station antenna, the lower the power output.
The highest SAR value for the model phone as reported to the FCC when tested for use at the ear is x.xW/kg
and when worn on the body, as described in this user guide, is x.xW/kg (Body-worn measurements differ
among phone models, depending upon available enhancements and FCC requirements).
While there may be differences between the SAR levels of various phones and at various positions, they all
meet the government requirement.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with
the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID:
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines for use with
an accessory that contains no metal and the positions the handset a minimum of 1.5 cm from the body. Use
of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you do not use a
body-worn accessory and are not holding the phone at the ear, position the handset a minimum of 1.5 cm
from your body when the phone is switched on.

YOUR PHONE-FRONT VIEW

YOUR PHONE-BACK VIEW

CHARGE THE BATTERY

Connect this end to phone’s USB port.

INSERT SIM AND MicroSD CARD

Please insert the SIM card according to the label on the phone. Make sure that the clipped corner of the SIM
card and the metallic contacts are facing the correct direction. Slide the SIM card into the slot until it doesn't
move up any further.
At the top of SIM slot is the micro SD card slot. The direction in which the microSD card has to be inserted into
the designated slot is shown by an label on the phone.

SD Card
SIM