How it Works
Azbox
Loading...
Me
Hardware Manual
34 pgs1.74 Mb0

Azbox Me Hardware Manual

Hardware Manual
AZBox 2011 | english rev. 1.2
2
AZBox Me | Hardware Manual | 2011 rev. 1.2
NOTE
product in the world of set top boxes: AZBox Me.
Before using the product, please read carefully all the useful information provided in this manual. It will help you take full advantage of the features of AZBox Me and will alert you to necessary safety precautions preceding its fi rst usage.
Please note that we are not liable for any losses or damage of personal data, resulting from any inappropriate use of the products. Additionally, we shall not be responsible for any eventual misunderstanding regarding the content of this manual as well as any other situation arising from the wrong usage of this product.
The information provided in this manual is confi dential and copyrighted. As such, it shall not be reproduced, altered, or distributed without the written consent of the company, OpenSAT, Lda. (www.azbox.com).
2
AZBox Me | Hardware Manual | 2011 rev. 1.2
3
AZBox Me | Hardware Manual | 2011 rev. 1.2
Table of Contents
NOTE 2 Abbreviations 4 Important Safety Information 4 Danger 4 Caution 5 Environmental responsibility 6
Additional Remarks 6
1. Package Contents 7
2. Product Overview 8
2.1. AZBox Me Features 9
2.2. The front panel 10
2.3. The rear panel 10
2.4. The side panel 11
2.5. The RCU (Remote Control Unit) 11
3. Installation 12
3.1. The RCU 12
3.2. AZBox Me Connections 12
3.3. Internal HDD installation 14
3.4. Powering on for the fi rst time 15
4. Troubleshooting 15
5. Identify Your Set-Top-Box 15
6. Technical Specifi cations 16
7. Contact and support information 17
3
AZBox Me | Hardware Manual | 2011 rev. 1.2
Table of Contents
NOTE 2 Abbreviations 4 Important Safety Information 4 Danger 4 Caution 5 Environmental responsibility 6
Additional Remarks 6
1. Package Contents 7
2. Product Overview 8
2.1. AZBox Me Features 9
2.2. The front panel 10
2.3. The rear panel 10
2.4. The side panel 11
2.5. The RCU (Remote Control Unit) 11
3. Installation 12
3.1. The RCU 12
3.1.1. Installing baterries in RCU 12
3.1.2. Using TV button 12
3.2. AZBox Me Connections 12
3.2.1. Connections to antenna 12
3.2.2. Connections to TV 13 I. HDMI connector 13 II. Component video connector 13 III. Composite video connector 13
3.2.3. Audio connection 14
3.2.4. Internet connection 14
3.3. Internal HDD installation 14
3.4. Powering on for the fi rst time 15
4. Troubleshooting 15
5. Identify Your Set-Top-Box 15
6. Technical Specifi cations 16
7. Contact and support information 17
4
AZBox Me | Hardware Manual | 2011 rev. 1.2
Abbreviations
AV Audio/Video
EPG Electronic Program Guide
HDMI High Defi nition Multimedia Interface
DVB Digital Video Broadcasting
DVB-S Digital Video Broadcasting- Satellite
DVB-T Digital Video Broadcasting - Terrestrial
LAN Local Area Network
OSD On Screen Display
PPV Pay Per View
RCU Remote Control Unit
STB Set Top Box
Important Safety Information
Before installation, please read carefully the important remarks below, in order to operate the receiver safely and properly.
O Always follow the instructions below to avoid the risk of injury to yourself or damage to your
equipment.
O If you do not intend to use this unlit for a long time, please pull the power plug out from the outlet.
Do not use a damaged power cord.
O Do not expose the unit to water or any liquid. In such a situation, turn off the power and on again
after 1-2 hours.
O Unplug the receiver from the AC power outlet before cleaning. Use only a damp cloth for cleaning
the exterior of the receiver.
O Install the dish with correct direction and angle. If the dish is not working properly, please contact
your local dealer
O Install the unit horizontally. Unbalanced installation may damage unit.
O Moving the unit suddenly from a hot to a cold area may cause damage.
O Operate the receiver in a ventilated area, one with suitable temperature, no direct sun rays, low
humidity and low vibration infl uence
O Do not put heavy objects on top of the unit.
O Do not use accessories or attachments not recommended by the manufacturer or authorized
representative, as they may cause hazards and will void the warranty.
Danger
DANGER indicates an immediate hazardous situation which, if not avoided, will result in death or serious injury.
O Never open the cover. It is very dangerous to touch the inner part of the unit, as it might result in
electric shock.
O Do not attempt to modify this receiver in any way. To do so may result in fi re, injury, electronic shock
or severe damage to you or your receiver. Internal inspection, maintenance and repairs should only be carried out by your dealer or OpenSAT.
O Please do not use this receiver in close proximity to fl ammable, chemical water or explosive gases,
as this could increase the risk of explosion.
O Make sure to turn off power switch and pull out power plug when moving product and do not
forcefully pull out power cord.
4
AZBox Me | Hardware Manual | 2011 rev. 1.2
Important Safety Information
Before installation, please read carefully the important remarks below, in order to operate the receiver safely and properly.
O Always follow the instructions below to avoid the risk of injury to yourself or damage to your
equipment.
O If you do not intend to use this unlit for a long time, please pull the power plug out from the outlet.
Do not use a damaged power cord.
O Do not expose the unit to water or any liquid. In such a situation, turn off the power and on again
after 1-2 hours.
O Unplug the receiver from the AC power outlet before cleaning. Use only a damp cloth for cleaning
the exterior of the receiver.
O Install the dish with correct direction and angle. If the dish is not working properly, please contact
your local dealer
O Install the unit horizontally. Unbalanced installation may damage unit.
O Moving the unit suddenly from a hot to a cold area may cause damage.
O Operate the receiver in a ventilated area, one with suitable temperature, no direct sun rays, low
humidity and low vibration infl uence
O Do not put heavy objects on top of the unit.
O Do not use accessories or attachments not recommended by the manufacturer or authorized
representative, as they may cause hazards and will void the warranty.
Danger
DANGER indicates an immediate hazardous situation which, if not avoided, will result in death or serious injury.
O Never open the cover. It is very dangerous to touch the inner part of the unit, as it might result in
electric shock.
O Do not attempt to modify this receiver in any way. To do so may result in fi re, injury, electronic shock
or severe damage to you or your receiver. Internal inspection, maintenance and repairs should only be carried out by your dealer or OpenSAT.
O Please do not use this receiver in close proximity to fl ammable, chemical water or explosive gases,
as this could increase the risk of explosion.
O Make sure to turn off power switch and pull out power plug when moving product and do not
forcefully pull out power cord.
5
AZBox Me | Hardware Manual | 2011 rev. 1.2
Caution
A. Do not place the receiver on an unstable cart, stand, tripod,
bracket, or table. The receiver may fall, causing serious personal injury and damage to the receiver.
B. The power supply should be near the equipment. Do not run
an extension lead to the unit.
C. Protect the power cord from being walked on or pinched. If
the cord is damaged, do not use the digital receiver and get the cord replaced.
D. Do not block or cover slots and openings in the receiver.
These are provided for ventilation and protection from overheating. Never place the receiver near or over a radiator or heat register. Do not place the receiver in an enclosure such as a cabinet without proper ventilation.
E. Do not stack the receiver on top of or below other electronic devices.
F. Operate the receiver using only the type of power source indicated on the marking label. Unplug the
receiver power cord by gripping the power plug, not the cord.
G. Route power supply cords so that they are not likely to be walked on or trodden or perforated
by items placed upon or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.
H. For added protection during a lightning storm, or when the receiver is left unattended and unused
for long periods of time, unplug it from the wall outlet and disconnect the lines between the receiver and the antenna. This will provide some protection against damage caused by lightning or power line surges.
I. Do not attempt to service the receiver yourself, as opening or removing covers may expose you to
dangerous voltage, and will void the warranty. Contact your dealer or OpenSAT.
O In case of any form of liquid or a foreign object enter the receiver, do not use it. Power off the
receiver, and then disconnect the power cord. You must contact your dealer or OpenSAT. Do not continue to use the receiver as this may cause a fi re or electric shock.
O Do not insert or drop metallic or infl ammable foreign objects into the receiver through ventilation
holes or access points, e.g. smart card slot. This may cause fi re or electric shock.
O Keep product away from severe vibration or magnetic objects
O Do not cover up or install it in places with poor ventilation, under direct sunlight or near objects that
generates heat.
O Do not connect a number of power plugs at the same time, this may cause fi re.
O To reduce the risk of electric shock don’t remove the ‘ cover (or back) and do not operate this
receiver with wet hands. Equipment service and maintenance should be performed only by trained personnel.
This symbol is intended to alert the user of the presence of uninsulated ‘dangerous voltage’ within the product’s enclosure that may be of suffi cient magnitude to constitute a risk of electric shock to persons.
The exclamation mark, within an equilateral triangle. Is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
5
AZBox Me | Hardware Manual | 2011 rev. 1.2
Caution
A. Do not place the receiver on an unstable cart, stand, tripod,
bracket, or table. The receiver may fall, causing serious personal injury and damage to the receiver.
B. The power supply should be near the equipment. Do not run
an extension lead to the unit.
C. Protect the power cord from being walked on or pinched. If
the cord is damaged, do not use the digital receiver and get the cord replaced.
D. Do not block or cover slots and openings in the receiver.
These are provided for ventilation and protection from overheating. Never place the receiver near or over a radiator or heat register. Do not place the receiver in an enclosure such as a cabinet without proper ventilation.
E. Do not stack the receiver on top of or below other electronic devices.
F. Operate the receiver using only the type of power source indicated on the marking label. Unplug the
receiver power cord by gripping the power plug, not the cord.
G. Route power supply cords so that they are not likely to be walked on or trodden or perforated
by items placed upon or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.
H. For added protection during a lightning storm, or when the receiver is left unattended and unused
for long periods of time, unplug it from the wall outlet and disconnect the lines between the receiver and the antenna. This will provide some protection against damage caused by lightning or power line surges.
I. Do not attempt to service the receiver yourself, as opening or removing covers may expose you to
dangerous voltage, and will void the warranty. Contact your dealer or OpenSAT.
6
AZBox Me | Hardware Manual | 2011 rev. 1.2
Environmental responsibility
Tthe packaging of AZBox consists only of reusable materials.
This symbol found both in the box and in the equipment indicates that the product should not be discarded with household waste.
Therefore, in case you want to dispose of your equipment, please put it in a recycling point, one specifi c for disposal of electrical and electronic equipment. In this way you are helping us protecting the environment.
Additional Remarks
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.
6
AZBox Me | Hardware Manual | 2011 rev. 1.2
Loading...
+ 23 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use