Axxess XSVI-1731-NAV Installation Instructions Manual

CAUTION!

All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.

XSVI-1731-NAV

INSTALLATION INSTRUCTIONS

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell
caps, etc.)

TABLE OF CONTENTS

Connections to be made .......................................2

Installing the XSVI-1731-NAV .................................3

Initializing the XSVI-1731-NAV ...............................3

APPLICATIONS

• Provides NAV outputs (parking brake, reverse, and speed sense)

• Pre-wired ASWC-1 harness included (ASWC-1 sold separately)

• Retains the factory backup camera

• Retains balance and fade

• Includes the AX-CAM6V 12-volt to 6-volt converter

• Micro “B” USB updatable

HONDA

Civic LX 2016-up

• XSVI-1731-NAV interface

• XSVI-1731-NAV harness

• AX-CAM6V 12-volt to 6-volt converter

Honda Data Interface 2016-up*

INTERFACE FEATURES

2

CONNECTIONS TO BE MADE

From the XSVI-1731-NAV harness to the aftermarket radio:

• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.

• Connect the Yellow wire to the battery wire.

• Connect the Red wire to the accessory wire.

• If the vehicle is equipped with a factory backup camera:

• Connect the Red wire labeled “6-volt camera” to the AX-CAM6V.

• Connect the Yellow RCA jack to the backup camera input.

• If the aftermarket radio has an illumination wire, connect the Orange wire to it.

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the White wire to the left front positive speaker output.

• Connect the White/Black wire to the left front negative speaker output.

• Connect the Green wire to the left rear positive speaker output.

• Connect the Green/Black wire to the left rear negative speaker output.

• Connect the Purple wire to the right rear positive speaker output.

• Connect the Purple/Black wire to the right rear negative speaker output.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the Blue/Pink wire to the VSS/speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

Note:

Before connecting this wire, also refer to the “AX-CAM6V 12-volt to 6-volt” converter

section.

• Connect the Light Green wire to the parking brake wire.

AX-CAM6V 12-volt to 6-volt converter:

• Connect the Blue/Red wire to the Red wire labeled “Camera Power 6V”.

• Connect the Blue/White wire to the Green/Purple wire.
Note:

The Green/Purple wire will connect to both the AX-CAM6V, and the aftermarket radio.

12-pin pre-wired ASWC-1 harness:

• This harness is to be used along with the optional ASWC-1 (not included) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.

Note:

Disregard the harness that comes with the ASWC-1.

• Connect the Red wire to the accessory wire.