Axxess HPZM2 User Manual

HPZM2 USER’S MANUAL

JULY 10 2014

United States (FCC)

This equipment complies with Part 15 of the FCC rules and regulations.

To fulfill FCC Certification requirements, and OEM manufacturer must comply with the following regulations: (1) The modular
transmitter must be labelled with its own FCC ID number, and, if the FCC ID number is not visible when the module is
installed inside another advice, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:

Example of label required for OEM product containing HPZM2 module

Contains FCC ID: HPZM2

WARNING: The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter must be labelled

with its own FCC ID number. This includes a clearly visible label on the outside of the final product enclosure that displays
the content shown below. If the FCC ID is not visible then the outside of the device into which the module is installed must
also display a label referring to the enclosed equipment.

IMPORTANT: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation (FCC 15.19). The internal / external antenna(s) used for this mobile
transmitter must provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.

IMPORTANT: The module is limited to OEM installation only. OEM integrators are responsible for ensuring that the end-user
has no manual instructions to remove or install module. The module is limited to installations in mobile or fixed applications,
according to Part 2.1091(b). Separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.

IMPORTANT: OEM integrators must include the following instructions and statements in the user manual (i.e. end product):
(1) statements and labeling as required per Part 15.19 and 15.21, and (2) end-users must be provided with
transmitter/antenna installation requirements and operating conditions for satisfying RF exposure compliance: (i) a separate
section should clearly state “FCC RF Exposure requirements”, (ii) Required operating conditions for end users, (iii) antenna
or transmitter installation requirements where relevant (i.e. “ The internal / external antenna(s) used for this mobile
transmitter must provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”)

HPZM2 USER’S MANUAL

JULY 10 2014