Axxess GMOS-044 Installation Instructions Manual

Installation instructions for part GMOS-044

Axxess Integrate

CAUTION!

All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.

Connections to be made ..................................... 2-3

Installing the GMOS-044 ....................................... 3

Initializing the GMOS-044...................................... 3

Adjusting the GMOS-044 ....................................... 4

Personalization Menu ............................................ 4

No OE Steering Wheel Controls ............................. 5

• Provides accessory power (12-volt 10-amp)

• Retains R.A.P. (retained accessory power)

• Used in amplified or non-amplified systems

• Retains chimes

• Provides NAV outputs (parking brake, reverse, mute, and speed sense)

• Prewired ASWC-1 harness included (ASWC-1 sold separately)

• Retains OnStar/OE Bluetooth

• Adjustable volume for chimes and OnStar

• High level speaker input

• Micro “B” USB updatable

• Retains balance and fade

FEATURES

• Cutting tool • Crimping tool • Tape

• Connectors (example: butt-connectors, bell caps, etc.)

TOOLS REQUIRED

GMOS-044

Chevrolet Cruze 2011-2015 / Cruze Limited 2016

(

with monochrome screen)

• GMOS-044 interface • GMOS-044 harness

INTERFACE COMPONENTS

Table of Contents

GMOS-044

2

Connections to be made

From the 16-pin harness to the aftermarket radio:

• Connect the Red wire to the accessory wire.

• Connect the Orange/White wire to the illumination wire. If the aftermarket
radio has no illumination wire just tape off the Orange/White wire.

• If equipped with a factory amplifier, connect the Blue/White wire to the amp
turn on wire.

• Connect the White wire to the left front positive speaker output.

• Connect the White/Black wire to the left front negative speaker output.

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the Brown wire to the mute wire. If the aftermarket radio does not
have a Mute wire, tape up the Brown wire.

The following (3) wires are only for multimedia/navigation radios that require these wires

.

• Connect the Blue/Pink wire to the VSS/speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire.

From the 18-pin harness to the aftermarket radio:

• Connect the Black wire with the ring terminal to the radio chassis with the ISO
screw that is supplied with radio.

Note: This wire must be connected as instructed otherwise the interface
will not be functional.

• The Black/Yellow wire will be discussed later in this manual.

• If the vehicle does not come equipped with steering wheel controls, connect
the Green/Orange wire to the Green/Orange wire on the ASWC-STALK (sold
separately) to retain the personalization features. See the “No OE Steering
Wheel Controls” section for more information and wiring of the ASWC-STALK.

From the 44-pin harness to the aftermarket radio:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• Connect the Green wire to the left rear positive speaker output.

Continued on the next page