Axxess GMOS-04 Installation Instructions Manual

Installation instructions for part GMOS-04
REV. 3/13/2017 NSTGMOS-04
®
axxessinterfaces.com • metraonline.com
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Axxess Integrate
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains chimes
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
• Designed for amplified models
• Retains balance and fade
• USB-CAB updatable (sold separately)
• GMOS-04 interface • GMOS-04 harness
• 16-pin harness with stripped leads
05;,9-(*,-,(;<9,:
05;,9-(*,*64765,5;:
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
;663:9,8<09,+
GMOS-04
GM Data Interface
2000-2013
(7730*(;065:
See inside front cover
Connections to be made ..................................... 3-4
Installing the GMOS-04 ..........................................5
Initializing the GMOS-04.........................................5
Adjusting the GMOS-04 .......................................... 5
Table of Contents
GMOS-04
2
Applications
BUICK
Century 2004-2005 LaCrosse 2005-2009 Rainier 2004-2007 Regal 2004 Rendezvous 2002-2007 Terraza 2005-2007
CADILLAC
Escalade 2003-2006 Escalade ESV 2003-2006 Escalade EXT 2003-2006
CHEVROLET
Avalanche 2003-2006 Cavalier 2000-2005 Colorado 2004-2012 Corvette 2005-2013 Express 2003-2007 Impala 2000-2005 Kodiak C4500-C8500 2003-2009 Malibu 2001-2003 Malibu Classic 2004-2005 Monte Carlo 2000-2005
CHEVROLET (CONT)
Silverado 2003-2006 Silverado Classic 2007 SSR 2003-2006 Suburban 2003-2006 Tahoe 2003-2006 Trailblazer 2002-2006 Trailblazer 2007-2009 Uplander 2005-2008
GMC
Canyon 2004-2012 Envoy 2002-2006 Envoy 2007-2009 Savanna 2003-2007 Sierra 2003-2006 Sierra Classic 2007 TopKick C4500-C8500 2005-2009 Yukon 2003-2006
HUMMER
H2 2003-2007 H3/H3t 2006-2010
ISUZU
Ascender 2003-2008 H-Series 2003-2008 I-Series 2006-2008
OLDSMOBILE
Alero 2001-2004 Bravada 2002-2004 Intrigue 2002
PONTIAC
Aztec 2001-2005 Grand Am 2001-2005 Grand Prix 2004-2008 Montana SV6 2005-2006 Sunfire 2000-2005
SAAB
9-7x 2005-2009
SATURN
Relay 2005-2007
GMOS-04
3
Connections to be made
Attention! This vehicle may come equipped with a digital amplifier. Ensure that the factory radio was removed with all settings in their default positions.
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an accessory wire
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear sound from the factory amplifier.
If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
Note: There is an Orange/White wire on the GMOS-04 harness also. If a wire is
populated on the factory wiring harness, use that wire instead.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the mute wire is not connected, the radio will turn off when OnStar is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
The following (3) wires are only for multimedia/navigation radios that require these wires
.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
From the GMOS-04 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
Note: Only connect this wire if it is populated on the factory wiring harness. Otherwise use the Orange/White wire on the 16-pin harness with stripped leads.
• The Black/Yellow wire is used for OnStar level adjustment for models that do not come equipped with steering wheel controls. Refer to the OnStar level Adjustment section for further instructions.
Tape off and disregard the following (1) wire, it will not be used in this application
:
Orange/White.
Continued on the next page
GMOS-04
4
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
• The following wire(s) must be cut before programming the ASWC-1: * For the following vehicles cut the White/Green, Green/Orange,
and Orange/Green wires.
** For the following vehicles cut the White/Green, Pink, and
Green/Orange wires. *** For the following vehicles cut the Pink and Green/Orange wires. † For the following vehicles cut the White/Green and Pink wires. ‡ For the following vehicles cut the Pink wire.
BUICK
Century † 2004-2005 LaCrosse † 2005-2009 Rainer * 2004-2007 Regal † 2004 Rendezvous ‡ 2002-2007 Terraza ‡ 2005-2007
CADILLAC
Escalade, Escalade ESV & EXT * 2003-2006
CHEVROLET
Avalanche * 2003-2006 Cavalier * 2000-2005 Colorado * 2004-2012 Corvette *** 2007-2011 Corvette ‡ 2012-2013 Impala ** 2000-2005 Malibu 2001-2003 Malibu Classic 2004-2005 Monte Carlo ** 2000-2005
CHEVROLET (continued)
Silverado * 2003-2006 Silverado Classic * 2007 SSR * 2003-2006 Suburban * 2003-2006 Tahoe * 2003-2006 Trailblazer * 2002-2009 Uplander ** 2005-2008
GMC
Canyon * 2004-2012 Envoy * 2002-2009 Sierra * 2003-2006 Sierra Classic * 2007 Yukon * 2003-2006 Yukon XL * 2003-2006
HUMMER
H2 * 2003-2007
ISUZU
Ascender * 2003-2008
OLDSMOBILE
Alero ** 2001-2004 Bravada * 2002-2004 Intrigue ** 2002
PONTIAC
Aztec ** 2001-2005 Grand Am ** 2001-2005 Grand Prix ** 2004-2008 Montana SV6 ** 2005-2006 Sunfire * 2000-2005
SAAB
9-7x * 2005-2009
SATURN
Relay ** 2005-2007
Connections to be made (cont.)
GMOS-04
5
Installing the GMOS-04
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the GMOS-04 harness, into the interface.
• Connect the GMOS-04 harness to the wiring harness in the vehicle.
Note: If using the ASWC-1, connect it after you initialize and test the GMOS-04,
with the key in the off position.
Initializing the GMOS-04
Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an ASWC-1 connect it after you initialize and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, pause for a moment, and then to the accessory position. Test all functions of the installation for proper operation, before reassembling the dash.
Adjusting the GMOS-04
Audio level adjustment:
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio level; counterclockwise to lower the audio level.
• Once at a desired level, audio level adjustment is complete.
Chime level adjustment (for models without a digital amplifier *):
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s door; chimes will be heard.
• Wait 10 seconds, and then with a small screwdriver, turn the potentiometer clockwise to raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This will lock the chime volume at its current level.
* Please reference the “Service Parts Identification” sticker located in the glove box
for the RPO code Y91. If Y91 is present, then the vehicle is equipped with a digital amplifier. Refer to the vehicle owner’s manual to adjust the chimes.
OnStar Level Adjustment
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN button on the steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, or they no longer function, locate the Black/Yellow wire on the GMOS-04 harness.
While OnStar is speaking, tap the Black/Yellow wire to ground. Once the OnStar level is set, it will stay at that level until the Black/Yellow wire is tapped to ground again
.
Installation instructions for part GMOS-04
REV. 3/13/2017 NSTGMOS-04
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.
Metra recommends MECP certified technicians
®
axxessinterfaces.com • metraonline.com
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Axxess Integrate
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.
Loading...