3
CONNECTIONS TO BE MADE
The AX-LCD allows the retention of the vehicles personalization menu that is lost after removing the factory radio.
The DIN harness with leads is only for the following vehicles:
• Connect the Black wire to ground.
• Connect the Red wire to accessory power.
(this is the wire view of the factory harness)
For the Toyota Camry 2012-2014
The following connections are to be made to
the factory 28-pin connector behind the radio:
• Pink of the AX-LCD to pin-9
• Blue/Pink of the AX-LCD to pin-10
For the Mazda 6 2014-2015
The following connections are to be made to
the factory 24-pin connector behind the radio:
• Pink of the AX-LCD to pin-1L
• Blue/Pink of the AX-LCD to pin-1J
(this is the pin view of the factory harness)
For the Fiat 500L 2014-up,
Ram 1500/2500/3500 (without 8.4” touchscreen radio),
Chassis Cab 3500/4500/5500 (without 8.4”
touchscreen radio) 2013-up,
The following connections are to be made to the factory 52-pin
connector behind the radio:
31 40 49
52
44
41
10
1
(this is the pin view of the factory harness)
• Blue/Pink of the AX-LCD to pin-12
• Pink of the AX-LCD to pin-2
(For retaining the personalization menu that is lost when removing the factory radio)
(For retaining and controlling the factory satellite radio while using an Axxess Interface)
• Connect the DIN cable from the LCD screen into the DIN connector on the Axxess interface.
CONNECTIONS TO BE MADE